ST
A world leader in providing the semiconductor solutions that make a positive contribution to people’s lives, both today and in the future.
You are viewing an older revision! See the latest version
Supported shields
This table summarizes the different shields (non ST X-NUCLEO boards) tested on Nucleo and Discovery platforms.
Shields support notes
- (1) This shield requires SPI pins remapping because it uses a non-standard 6 pin SPI connector. Please refer to the shield page on mbed for more information.
- (2) To use this shield with ST Nucleo platforms you will need to remove SB13 and SB14 then bridge SB62 and SB63. This will enable the processor to communicate with the shield using the default serial connection, but will stop the comms going via the ST-Link and USB. Alternatively you could use other serial-enabled pins, which have to be connected to D0/D1 pins on the shield. Please refer to the the Nucleo pinout image for options.
- (3) This shield uses I2C on A4/A5 pins and requires bridging of A4<->D14 and A5<->D15.
- (4) To boot on external power, the PWR jumper (near the reset button) has to be switched to E5V position.