Seeed Ethernet Shield V2.0
The Seeed Ethernet Shield allows you to connect to the internet. It is based on the Wiznet W5100/W5200 ethernet chip providing a network (IP) stack capable of both TCP and UDP.
Example program for the Ethernet Shield V2.0 by SeeedStudio. The example gets an IP address via DHCP and then requests http://mbed.org/media/uploads/mbed_official/hello.txt
WIZ820io(W5200) network interface, EthernetInterface compatible.
Ethernet Shield from Seeed Studio is based on WIZ820io.
Note that this shield doesn't use the standard SPI pins, but relies on non-standard 6-pin SPI header located at the shield bottom. To make it work you will have to bridge those pins as shown on the image (the green SPI pins).
|Signal||Pin 1||Pin 2|
- To know more about it, please visit our wiki page http://www.seeedstudio.com/wiki/Ethernet_Shield_V2.0
- To get Seeed Ethernet Shield V2.0, please visit http://www.seeedstudio.com/depot/W5200-Ethernet-Shield-p-1577.html?cPath=19_17
You need to log in to post a discussion
7 years, 4 months ago
7 years ago