BLE_API wrapper library for STMicroelectronics' BlueNRG Bluetooth Low Energy expansion board shield (Component)
Dependents: Nucleo_Zumo_BLE_IDB04A1 contest_IOT5 contest_IOT6 contest_IOT_10 ... more
Fork of X_NUCLEO_IDB0XA1 by
Arduino Connector Compatibility Warning
X-NUCLEO-IDB04A1 and X-NUCLEO-IDB05A1 are Arduino compatible with an exception: instead of using pin D13
for the SPI clock, they use pin D3
.
The default configuration for this library is having the SPI clock on pin D3
.
To be fully Arduino compatible, X-NUCLEO-IDB04A1 and X-NUCLEO-IDB05A1 need a small HW patch.
For X-NUCLEO-IDB04A1 this patch consists in removing zero resistor R10
and instead soldering zero resistor R11
.
For X-NUCLEO-IDB05A1 this patch consists in removing zero resistor R4
and instead soldering zero resistor R6
.
In case you patch your board, then you also have to configure this library to use pin D13
to drive the SPI clock (see macro IDB0XA1_D13_PATCH
in file x_nucleo_idb0xa1_targets.h
).
If you use pin D13
for the SPI clock, please be aware that on STM32 Nucleo boards you may not drive the LED, otherwise you will get a conflict: the LED on STM32 Nucleo boards is connected to pin D13
.
Referring to the current list of tested platforms (see X-NUCLEO-IDB04A1 and X-NUCLEO-IDB05A1 pages), the patch is required by ST-Nucleo-F103RB; ST-Nucleo-F302R8; ST-Nucleo-F411RE; and ST-Nucleo-F446RE.
Diff: module.json
- Revision:
- 183:3bc6d59b9c81
- Parent:
- 176:33edcdbe9ce6
- Child:
- 184:47b7d9afc3a8
- Child:
- 193:54dd09ddd5c3
--- a/module.json Fri Nov 13 16:31:14 2015 +0100 +++ b/module.json Thu Nov 19 11:04:31 2015 +0100 @@ -25,6 +25,7 @@ "x-nucleo-idb0xa1/bluenrg-hci" ], "dependencies": { + "mbed-drivers": ">=0.11.3", "mbed-hal": "^1.0.0", "ble": "^2.0.0" }