ST / stm-spirit1-rf-driver

Prototype RF driver for STM Sub-1 GHz RF expansion board based on the SPSGRF-868 module for STM32 Nucleo.

Prototype RF Driver for STM Sub-1 GHz RF Expansion Boards based on the SPSGRF-868 and SPSGRF-915 Modules for STM32 Nucleo

Currently supported boards:

Note, in order to use expansion board X-NUCLEO-IDS01A4 in mbed you need to perform the following HW modifications on the board:

  • Unmount resistor R4
  • Mount resistor R7

Furthermore, on some Nucleo development boards (e.g. the NUCLEO_F429ZI), in order to be able to use Ethernet together with these Sub-1 GHz RF expansion boards, you need to compile this driver with macro SPIRIT1_SPI_MOSI=PB_5 defined, while the development board typically requires some HW modification as e.g. described here!

This driver can be used together with the 6LoWPAN stack (a.k.a. Nanostack).

Diff: source/NanostackRfPhySpirit1.cpp

Revision:
39:75481c4c6655
Parent:
38:5deec3ab2025
Child:
52:053dbc4b570f
diff -r 5deec3ab2025 -r 75481c4c6655 source/NanostackRfPhySpirit1.cpp
--- a/source/NanostackRfPhySpirit1.cpp	Wed Nov 23 07:00:33 2016 +0100
+++ b/source/NanostackRfPhySpirit1.cpp	Thu Nov 24 08:47:27 2016 +0100
@@ -841,7 +841,7 @@
     /*Type of RF PHY is SubGHz*/
     device_driver.link_type = PHY_LINK_15_4_SUBGHZ_TYPE;
 
-    /*Maximum size of payload is 255*/
+    /*Maximum size of payload*/
     device_driver.phy_MTU = MAX_PACKET_LEN;
 
     /*No header in PHY*/