ST / stm-spirit1-rf-driver

Prototype RF driver for STM Sub-1 GHz RF expansion board based on the SPSGRF-868 module for STM32 Nucleo.

Prototype RF Driver for STM Sub-1 GHz RF Expansion Boards based on the SPSGRF-868 and SPSGRF-915 Modules for STM32 Nucleo

Currently supported boards:

Note, in order to use expansion board X-NUCLEO-IDS01A4 in mbed you need to perform the following HW modifications on the board:

  • Unmount resistor R4
  • Mount resistor R7

Furthermore, on some Nucleo development boards (e.g. the NUCLEO_F429ZI), in order to be able to use Ethernet together with these Sub-1 GHz RF expansion boards, you need to compile this driver with macro SPIRIT1_SPI_MOSI=PB_5 defined, while the development board typically requires some HW modification as e.g. described here!

This driver can be used together with the 6LoWPAN stack (a.k.a. Nanostack).

Diff: source/NanostackRfPhySpirit1.cpp

Revision:
52:053dbc4b570f
Parent:
39:75481c4c6655
Child:
53:b036a3a850e6
--- a/source/NanostackRfPhySpirit1.cpp	Wed Feb 22 09:55:13 2017 +0100
+++ b/source/NanostackRfPhySpirit1.cpp	Thu Feb 23 13:29:35 2017 +0100
@@ -30,16 +30,7 @@
 
 static uint16_t stored_short_adr;
 static uint16_t stored_pan_id;
-static uint8_t stored_mac_address[8] = {
-		MBED_CONF_SPIRIT1_MAC_ADDRESS_0,
-		MBED_CONF_SPIRIT1_MAC_ADDRESS_1,
-		MBED_CONF_SPIRIT1_MAC_ADDRESS_2,
-		MBED_CONF_SPIRIT1_MAC_ADDRESS_3,
-		MBED_CONF_SPIRIT1_MAC_ADDRESS_4,
-		MBED_CONF_SPIRIT1_MAC_ADDRESS_5,
-		MBED_CONF_SPIRIT1_MAC_ADDRESS_6,
-		MBED_CONF_SPIRIT1_MAC_ADDRESS_7
-};
+static uint8_t stored_mac_address[8] = MBED_CONF_SPIRIT1_MAC_ADDRESS;
 
 #define RF_SIG_ACK_NEEDED (1<<0)
 static Thread rf_ack_sender(osPriorityRealtime);