Azoteq / IQS62x

Library to read and write Azoteq IQS6xx device registers via I2C.

Dependents:   IQS620_HelloWorld IQS622_HelloWorld IQS624_HelloWorld IQS621_HelloWorld ... more

Library: IQS62x

Library to read and write Azoteq IQS6xx device registers via I2C.

Supported Devices

Components / IQS620A
Ultra low power sensor for magnetic field, capacitive touch and inductive proximity. Empowers next-generation user interfaces.

Components / IQS621
Azoteq IQS621 ultra low power sensor for ambient light, magnetic field, capacitance and inductive proximity. Empowers next-generation user interfaces.

Components / IQS622
Azoteq IQS622 ultra low power sensor for ambient light, active (reflective) IR, magnetic field, capacitance and inductive proximity. Empowers next-generation user interfaces.

Components / IQS624
Ultra low power sensor for rotating magnetic field, capacitive touch, and inductive proximity. Empowers next-generation user interfaces.

Handy Table of ProxFusion Device Features


ALS = Ambient Light Sensor PIR = Passive Infrared

/media/uploads/AzqDev/mbed-azoteq-proxfusion-handy-table-of-product-features.jpg

Diff: IQS62x.h

Revision:
1:2f08ab339e17
Parent:
0:ce75ae1e8fc7
Child:
2:c16cb655d4a4
--- a/IQS62x.h	Sat Feb 04 07:19:09 2017 +0000
+++ b/IQS62x.h	Sat Feb 04 20:12:53 2017 +0000
@@ -4,9 +4,15 @@
 // Verify these 3 pin definitions if your hardware is not on the list of tested boards
 // If your board has an Arduino interface the definitions below will likely work
 
+#if defined (TARGET_LPC1768) || defined (TARGET_LPC11U24)
+#define IQS_I2C_CLOCK_PIN p27       /* on LPC1768/LPC11U24 this is marked as p27 */
+#define IQS_I2C_DATA_PIN p28        /* on LPC1768/LPC11U24 this is marked as p28 */
+#define IQS_READY_PIN p26           /* on LPC1768/LPC11U24 this is marked as p26 */
+#else
 #define IQS_I2C_CLOCK_PIN I2C_SCL   /* on NUCLEO boards this is marked as SCL/D15 on CN5 */
 #define IQS_I2C_DATA_PIN I2C_SDA    /* on NUCLEO boards this is marked as SDA/D14 on CN5 */
 #define IQS_READY_PIN D2            /* on NUCLEO boards this is marked as D2 on CN9 */
+#endif
 
 #define I2C_ADR (0x44 << 1) /* I2C address of IQS62x */
 #define I2CSPEED 100000 /* I2C clock speed */