Dynamixel Ax-12+ Servo¶

This page is intended as a write-up / tear-down of the the Dynamixel AX-12+ servo motor that was used in the http://mbed.org/etch-a-sketch demo at Embedded Systems Conference.

Introduction¶

This little beast is a highly featured peice of kit. It's not the cheapest servo money can buy, but it is certainly very versatile, and delivers a serious bang for your buck.

The headline features are:

• 55g
• 7v - 10v supply
• 900mA maximum current
• 16.5kg/cm Holding torque
• 300 degree or continuous rotation
• Half duplex serial (8-N-1) interface, up to 1Mbps
• Feedback for position, temperature, load, voltage etc

It is really mechanically sound too, and comes with a mounting plate, a bracket to fit to the spindle and plenty of nuts and bolts to bolt it all together. It has been designed so that one servo canbe mounted on the spindle of another so you can do multple degrees of freedom just by mounting them on eachother.