first 2016/02 SDFileSystemDMA inherited from Official SDFileSystem.
Dependents: SDFileSystemDMA-test DmdFullRGB_0_1
Fork of SDFileSystemDMA by
SDFileSystemDMA is enhanced SDFileSystem library for STM32 micros by using DMA functionality.
Max read transfer rate reaches over 2MByte/sec at 24MHz SPI clock if enough read buffer size is set.
Even though minimum read buffer size (512Byte) is set, read transfer rate will reach over 1MByte/sec at 24MHz SPI Clock.
( but depends on the ability of each SD card)
Test program is here.
https://developer.mbed.org/users/mimi3/code/SDFileSystemDMA-test/
Supported SPI port is shown below table.
(v): Verified. It works well.
(w): Probably it will work well. (not tested)
(c): Only compiled. (not tested)
(f): Over flash.
(r): Only read mode. (when _FS_READONLY==1)
(u) Under construction
(z): Dose not work.
Caution
If your board has SRAM less than or equal to 8KB, the buffer size must be set to 512 Bytes.
Supported Boards:
Cortex-M0
Board | SRAM | SPI1 | SPI2 | SPI3 |
---|---|---|---|---|
NUCLEO-F030R8 | 8KB | (v) | ||
DISCO-F051R8 | 8KB | (w) | ||
4KB | (f) | |||
NUCLEO-F042K6 | 6KB | (r) | ||
NUCLEO-F070RB | 16KB | (w) | ||
NUCLEO-F072RB | 16KB | (w) | ||
NUCLEO-F091RC | 32KB | (c) |
Cortex-L0
Board | SRAM | SPI1 | SPI2 | SPI3 |
---|---|---|---|---|
DISCO-L053C8 | 8KB | (c) | ||
NUCLEO-L053R8 | 8KB | (c) | ||
NUCLEO-L073RZ | 20KB | (c) |
Cortex-M3
Board | SRAM | SPI1 | SPI2 | SPI3 |
---|---|---|---|---|
DISCO-F100RB | 8KB | (v) | (v) | - |
BLUEPILL-F103CB | 20KB | (w) | (w) | - |
NUCLEO-F103RB | 20KB | (v) | (v) | - |
NUCLEO-L152RE | 80KB | (v) | (w) | - |
MOTE-L152RC | 32KB | (w) | (w) | - |
Cortex-M4
F3
Board | SRAM | SPI1 | SPI2 | SPI3 |
---|---|---|---|---|
DISCO-F303VC | 40KB | - | (v) | (v) |
NUCLEO-F303RE | 64KB | (w) | (w) | (w) |
NUCLEO-F302R8 | 16KB | - | - | (c) |
NUCLEO-F303K8 | 12KB | (c) | - | - |
DISCO-F334C8 | 12KB | (c) | - | - |
NUCLEO-F334R8 | 12KB | (c) | - | - |
F4
Board | SPI1 | SPI2 | SPI3 |
---|---|---|---|
ELMO-F411RE | (w) | - | (w) |
MTS-MDOT-F411RE | (u) | - | (u) |
MTS-DRAGONFLY-F411RE | (w) | - | (w) |
NUCLEO-F411RE | (v) | - | (v) |
NUCLEO-F401RE | (w) | - | (w) |
MTS-MDOT-F405RG | (u) | - | (u) |
NUCLEO-F410RB | (c) | - | (c) |
NUCLEO-F446RE | (c) | - | (c) |
NUCLEO-F429ZI | (c) | - | (c) |
B96B-F446VE | (c) | - | (c) |
NUCLEO-F446ZE | (c) | - | (c) |
DISCO-F429ZI | (u) | - | (u) |
DISCO-F469NI | (c) | - | (c) |
Information
This library is set to use "short file name" in SDFileSystemDMA/FATFileSystem/ChaN/ffconf.h . ( _USE_LFN=0)
You can change this option to _USE_LFN=1 .
spi_dma/spi_dma_stm32f4.c
- Committer:
- mimi3
- Date:
- 2016-02-13
- Revision:
- 2:0e871408d51b
- Child:
- 18:1b1a0e68008a
File content as of revision 2:0e871408d51b:
#if defined(TARGET_STM32F4) /* This file is licensed under Apache 2.0 license. (C) 2016 dinau */ #include "spi_dma.h" #define DMAx_CLK_ENABLE() __DMA2_CLK_ENABLE() #define SPIx_TX_DMA_STREAM DMA2_Stream3 #define SPIx_RX_DMA_STREAM DMA2_Stream2 #define SPIx_TX_DMA_CHANNEL DMA_CHANNEL_3 #define SPIx_RX_DMA_CHANNEL DMA_CHANNEL_3 #define readReg( reg, mask) ( (reg) & (mask) ) #if 0 static SPI_HandleTypeDef Spi2Handle; #endif void spi_dma_get_info( SPI_TypeDef *spi ) { SPI_HandleTypeDef *hspi; if( spi == SPI1 ){ hspi = &Spi1Handle; } #if 0 else { hspi = &Spi2Handle; } #endif hspi->Instance = spi; hspi->Init.Mode = readReg(spi->CR1, SPI_MODE_MASTER); hspi->Init.BaudRatePrescaler = readReg(spi->CR1, SPI_CR1_BR); hspi->Init.Direction = readReg(spi->CR1, SPI_CR1_BIDIMODE); hspi->Init.CLKPhase = readReg(spi->CR1, SPI_CR1_CPHA); hspi->Init.CLKPolarity = readReg(spi->CR1, SPI_CR1_CPOL); hspi->Init.CRCCalculation = readReg(spi->CR1, SPI_CR1_CRCEN); hspi->Init.CRCPolynomial = spi->CRCPR & 0xFFFF; hspi->Init.DataSize = readReg(spi->CR1, SPI_CR1_DFF); hspi->Init.FirstBit = SPI_FIRSTBIT_MSB; hspi->Init.NSS = readReg(spi->CR1, SPI_CR1_SSM); hspi->Init.TIMode = SPI_TIMODE_DISABLED; hspi->State = HAL_SPI_STATE_READY; } void spi_dma_handle_setup( SPI_TypeDef *spi, uint8_t mode ){ /* Peripheral DMA init*/ if( spi == SPI1 ){ /* TX: */ hdma_spi1_tx.Instance = SPIx_TX_DMA_STREAM; hdma_spi1_tx.Init.Channel = SPIx_TX_DMA_CHANNEL; hdma_spi1_tx.Init.Direction = DMA_MEMORY_TO_PERIPH; hdma_spi1_tx.Init.PeriphInc = DMA_PINC_DISABLE; if (mode == DMA_SPI_READ){ hdma_spi1_tx.Init.MemInc = DMA_MINC_DISABLE; } else{ hdma_spi1_tx.Init.MemInc = DMA_MINC_ENABLE; } hdma_spi1_tx.Init.PeriphDataAlignment = DMA_PDATAALIGN_BYTE; hdma_spi1_tx.Init.MemDataAlignment = DMA_MDATAALIGN_BYTE; hdma_spi1_tx.Init.Mode = DMA_NORMAL; hdma_spi1_tx.Init.Priority = DMA_PRIORITY_HIGH; /**/ hdma_spi1_tx.Init.FIFOMode = DMA_FIFOMODE_DISABLE; hdma_spi1_tx.Init.FIFOThreshold = DMA_FIFO_THRESHOLD_FULL; hdma_spi1_tx.Init.MemBurst = DMA_MBURST_SINGLE; hdma_spi1_tx.Init.PeriphBurst = DMA_PBURST_SINGLE; /**/ HAL_DMA_Init(&hdma_spi1_tx); __HAL_LINKDMA( &Spi1Handle,hdmatx,hdma_spi1_tx); /* RX: */ hdma_spi1_rx.Instance = SPIx_RX_DMA_STREAM; hdma_spi1_rx.Init.Channel = SPIx_RX_DMA_CHANNEL; hdma_spi1_rx.Init.Direction = DMA_PERIPH_TO_MEMORY; hdma_spi1_rx.Init.PeriphInc = DMA_PINC_DISABLE; if (mode == DMA_SPI_READ){ hdma_spi1_rx.Init.MemInc = DMA_MINC_ENABLE; } else{ hdma_spi1_rx.Init.MemInc = DMA_MINC_DISABLE; } hdma_spi1_rx.Init.PeriphDataAlignment = DMA_PDATAALIGN_BYTE; hdma_spi1_rx.Init.MemDataAlignment = DMA_MDATAALIGN_BYTE; hdma_spi1_rx.Init.Mode = DMA_NORMAL; hdma_spi1_rx.Init.Priority = DMA_PRIORITY_LOW; /**/ hdma_spi1_rx.Init.FIFOMode = DMA_FIFOMODE_DISABLE; hdma_spi1_rx.Init.FIFOThreshold = DMA_FIFO_THRESHOLD_FULL; hdma_spi1_rx.Init.MemBurst = DMA_MBURST_SINGLE; hdma_spi1_rx.Init.PeriphBurst = DMA_PBURST_SINGLE; /**/ HAL_DMA_Init(&hdma_spi1_rx); __HAL_LINKDMA( &Spi1Handle,hdmarx,hdma_spi1_rx); } #if 0 else if( spi == SPI2 ) { } #endif } void spi_dma_irq_setup( SPI_TypeDef *spi) { if( spi == SPI1 ) { /* DMA controller clock enable */ DMAx_CLK_ENABLE(); /* DMA interrupt init */ HAL_NVIC_SetPriority(DMA2_Stream3_IRQn, 0, 1); HAL_NVIC_EnableIRQ( DMA2_Stream3_IRQn); HAL_NVIC_SetPriority(DMA2_Stream2_IRQn, 0, 0); HAL_NVIC_EnableIRQ( DMA2_Stream2_IRQn); } #if 0 else if ( spi == SPI2 ){ } #endif } void DMA2_Stream2_IRQHandler(void) { HAL_DMA_IRQHandler(&hdma_spi1_rx); } void DMA2_Stream3_IRQHandler(void) { HAL_DMA_IRQHandler(&hdma_spi1_tx); } #endif /* TARGET_STM32F4 */