Ksenia Kondrashova / Mbed 2 deprecated Temp_&_RH_at_TFT_with_touchscreen-ENG

HYT humidity & temp sensor polling / showing received data at TFT with capacitive touchscreen

Dependencies:   FT800_2 HYT mbed

Homepage

Table of Contents

  1. Hardware
  2. Connection

HYT humidity & temperature sensor: polling and showing data at TFT via graphical controller FT800/FT801.

Hardware

For documentation on the FT800 library, please refer to the library pages.

Connection

MCU-board to TFT-module

MCU-board is connected to TFT-module via Break Out Board. You need 6 signals to connect: SCK, MOSI and MISO are connected to a SPI channel, SS is the chip select signal, PD work as powerdown and INT for interrupts from TFT to MCU.

/media/uploads/Ksenia/4_-22-.jpg

You have to connect VDD to BLVDD at Break Out Board if you use the board:

/media/uploads/Ksenia/4_-5-.jpg

MCU-board to HYT sensor

MCU-board is connected to sensor via I2C. Remember to use pull-up resisrors there:

/media/uploads/Ksenia/freshpaint-20-2016.09.16-10.37.03.png

Подробнее в статьях Как перестать бояться и полюбить mbed [Часть 1 - 5] на https://habrahabr.ru/users/uuuulala/topics/

All wikipages