Measuring air flow, relative humidity & temperature, then showing results at TFT

Dependencies:   FT800_2 HYT mbed

Air flow is measured with FS7 sensor by IST-AG, humidity & temperature are measured by HYT-271 sensor by IST. Graphs displayed it TFT by Riverdi via graphical controller FFT801.

Hardware

For documentation on the FT800 library, please refer to the library pages.

Connection

MCU-board to TFT-module

MCU-board is connected to TFT-module via Break Out Board. You need 6 signals to connect: SCK, MOSI and MISO are connected to a SPI channel, SS is the chip select signal, PD work as powerdown and INT for interrupts from TFT to MCU.

/media/uploads/Ksenia/4_-22-.jpg

You have to connect VDD to BLVDD at Break Out Board if you use the board:

/media/uploads/Ksenia/4_-5-.jpg

MCU-board to HYT sensor

MCU-board is connected to sensor via I2C. Remember to use pull-up resisrors there:

/media/uploads/Ksenia/freshpaint-20-2016.09.16-10.37.03.png

MCU-board to FS7 sensor

MCU-board is connected to sensor via FS flowmodule. FS-flowmodul is a PCB implementing bridge circuit which is necessary for FS7.

https://habrastorage.org/files/b25/056/287/b250562871614b4ca4286af885f1fa24

https://habrastorage.org/files/72d/04c/cac/72d04ccac07b4fcfb436e0ffbac73066

Changes

RevisionDateWhoCommit message
0:3f440c2facb0 2017-03-16 Ksenia Initial Commit default tip