Emre Eken / Mbed OS MAX30001 SYS EvKit

MAX30001-MAX32630FTHR SYS EvKit

Dependencies:   USBDevice max32630fthr

Max30001 EVKIT Summary

The MAX30001 EVKIT SYS-MBED Evaluation System (EV System) is used to evaluates the MAX30001 sensor, which is an ECG (electrocardiogram), biopotential and bioimpedance analog front end solution for wearable applications. The full EV System consists of the MAX32630FTHR Development board (DEV board) and MAX30001 sensor board and the evaluation software. The EvKit features EKG, PACE, RtoR (R-peak timing), Bio-Z, and raw data logging.

The MAX30001 EVKIT SYS-MBED evaluation system is assembled, tested and contains the necessary circuitry and connections to evaluate the MAX30001 sensor.

When evaluated as an EV System, the MAX32630FTHR board provides the necessary logic rails, master clock, SPI, USB-to-Serial interfaces that are needed to evaluate the MAX30001 sensor board. MAX32630FTHR can be used as an independent development platform. Another wiki page for that platform is available here.

Communication with the DEV board is facilitated by Windows 7, Windows 8 and Windows 10 compatible software that provides a simple and intuitive graphical user interface (GUI).

#ifndef _LOGGING_H_
#define _LOGGING_H_

#include "mbed.h"

/**
* @brief This will read the mission location and if there is something valid,
* then run the  Logging_ProcessMissionCmds()
* @param cmdBuffer buffer
*/
uint32_t Logging_IsMissionDefined(uint8_t *cmdBuffer);

int8_t Logging_ReadMissionFromSDCard(uint8_t *buffer);

int8_t Logging_ReadMissionFromFlash(uint8_t *buffer);

// return the page where mission is defined, Mission specific
uint32_t Logging_GetMissionStartPage(void);

// return the page where the mission definition ends, Mission specific
uint32_t Logging_GetMissionEndPage(void);

// Returns the location where the Writing can start from, for data logging...
uint32_t Logging_GetLoggingStartPage(void);

// Returns the end location available where the Flash ends essentially.... for
// data logging.
uint32_t Logging_GetLoggingEndPage(void);

// returns one if the usb is connected, zero if not
uint32_t Usb_IsConnected(void);

void Logging_SetStart(bool state);

bool Logging_GetStart(void);

#endif /* _LOGGING_H_ */