u-blox / battery-gauge-bq27441

This class provides APIs to all of the registers of the TI BQ27441 battery gauge, as used on the u-blox C030 board. The caller should instantiate an I2C interface and pass this to init(), which will initialise the chip and place it into its lowest power state. When battery gauging is enabled, the getRemainingCapacity()/getRemainingPercentage() API calls may be used; otherwise the chip will be maintained in its lowest power state until a voltage/current/temperature reading is requested.

Dependents:   example-battery-gauge-bq27441

doc/lipo_gauge_bq27441-g1.pdf@6:998cc334f8f2, 2017-12-13 (annotated)

Committer:
breadboardbasics
Date:
Wed Dec 13 17:14:51 2017 +0000
Revision:
6:998cc334f8f2
Parent:
4:e6208506ebc7 
Fixes current = 0 problem and adds power measurement capability

Who changed what in which revision?

UserRevisionLine numberNew contents of line
RobMeades 4:e6208506ebc7 1 (binary:application/pdf)