Sensor control program for mbed OS. / Mbed OS non-os_oss

Important changes to repositories hosted on mbed.com

Mbed hosted mercurial repositories are deprecated and are due to be permanently deleted in July 2026.

To keep a copy of this software download the repository Zip archive or clone locally using Mercurial.

It is also possible to export all your personal repositories from the account settings page.

Fork of non-os_oss by Rikita YAMADA

You are viewing an older revision! See the latest version

HW_Config

Table of Contents

  1. Hardware configuration
  2. Serial communication configuration
  3. About connectors

Hardware configuration

Sensor daughter board

Put each sensor daughter board to the appropriate place. Some combo sensor (e.g. Accelerometer & Gyroscope) are designed to fit one of them. All daughter boards have 15 pins and are divided into 7 and 8. Please carefully check the place of No.1 pin and the number of pins. Then you will find the right place.

/media/uploads/rikita/sensor-eva-daughter.jpg

Choose power supply level

You can choose each sensor's power supply voltage and interface signal level. When jumper is placed 1-2 pins, 3.0v is selected. When jumper is placed 2-3, 1.8v is selected.

  • MAG: magnetometer power supply.
  • ACC: accelerometer power supply.
  • GYR: gyroscope power supply.
  • VID: interface signal level.

/media/uploads/rikita/sensor-eva-jumper.jpg

Known bugs

  • NRST pin does not work. When new BIN file is drag'n'droped on NUCLEO's mass storage directory, reset function by ST-LINK does not work. Please bend JP7-3 pin of Arduino-Sensor-Evaluation board. If NRST pin is open, reset pin of magnetometer is undefined. To prevent unstable state, pull-up JP7-3 pin to IOREF level (connect JP7-2 and JP7-3 pin).

Serial communication configuration

By remove/soldering 0 ohm resisters, you can choose SPI or I2C communication.

I2C (default)

  • IC3 is enabled.
  • IC4 is disabled.
  • IC5 is enabled.
  • X_SCL - SCL is connected, SCK is disconnected.
  • X_SDA - SDA is connected, MOSI is disconnected.
  • X_CSB_IN is pull up/down (depends on device), X_CSB is disconnected.
  • X_SO is open/pull up/pull down (depends on device), MISO is disconnected.

SPI

  • IC3 is disabled.
  • IC4 is enabled.
  • IC5 is enabled.
  • X_SCL - SCK is connected, SCL is disconnected.
  • X_SDA - MOSI is connected, SDA is disconnected.
  • X_CSB_IN is X_CSB is connected, DON'T pull up/pull down.
  • X_SO -MISO is connected, DON'T pull up/pull down.

About connectors

Through JP5 to JP8 connectors are designed to be compatible with Arduino. Signal level of Arduino connector is converted from 3.3V to 3.0/1.8V. But if CPU board's interface is 1.8V, level shifter is not needed. In such case, set level shifter ICs (i.e. IC3, 4 and 5) to disabled, then use SV7 connector. SV7 connector is connected sensor daughter board directory.

Schematics

Download

All wikipages