Prototype RF driver for STM Sub-1 GHz RF expansion board based on the SPSGRF-868 module for STM32 Nucleo.

Prototype RF Driver for STM Sub-1 GHz RF Expansion Boards based on the SPSGRF-868 and SPSGRF-915 Modules for STM32 Nucleo

Currently supported boards:

Note, in order to use expansion board X-NUCLEO-IDS01A4 in mbed you need to perform the following HW modifications on the board:

  • Unmount resistor R4
  • Mount resistor R7

Furthermore, on some Nucleo development boards (e.g. the NUCLEO_F429ZI), in order to be able to use Ethernet together with these Sub-1 GHz RF expansion boards, you need to compile this driver with macro SPIRIT1_SPI_MOSI=PB_5 defined, while the development board typically requires some HW modification as e.g. described here!

This driver can be used together with the 6LoWPAN stack (a.k.a. Nanostack).

Committer:
Wolfgang Betz
Date:
Fri Mar 10 14:22:38 2017 +0100
Revision:
55:2bfbf1d07c14
Parent:
54:0f6612d36a29
Child:
56:f9d8d8bb503f
Clarify development board HW mod requirement

Who changed what in which revision?

UserRevisionLine numberNew contents of line
Wolfgang Betz 50:7f70089ba05f 1 # Prototype RF Driver for STM Sub-1 GHz RF Expansion Boards based on the SPSGRF-868 Module for STM32 Nucleo #
Wolfgang Betz 50:7f70089ba05f 2
Wolfgang Betz 50:7f70089ba05f 3 Currently supported boards:
Wolfgang Betz 50:7f70089ba05f 4 * [X-NUCLEO-IDS01A4](http://www.st.com/content/st_com/en/products/ecosystems/stm32-open-development-environment/stm32-nucleo-expansion-boards/stm32-ode-connect-hw/x-nucleo-ids01a4.html)
Wolfgang Betz 50:7f70089ba05f 5
Wolfgang Betz 50:7f70089ba05f 6 **Note**, in order to use expansion board `X-NUCLEO-IDS01A4` in mbed you need to perform the following HW modifications on the board:
Wolfgang Betz 50:7f70089ba05f 7 * **Un**mount resistor `R4`
Wolfgang Betz 50:7f70089ba05f 8 * **Mount** resistor `R7`
Wolfgang Betz 50:7f70089ba05f 9
Wolfgang Betz 55:2bfbf1d07c14 10 Furthermore, on some Nucleo development boards (e.g. the [NUCLEO_F429ZI](https://developer.mbed.org/platforms/ST-Nucleo-F429ZI/)), in order to be able to use Ethernet together with these Sub-1 GHz RF expansion boards, you need to compile this driver with macro `SPIRIT1_SPI_MOSI=PB_5` defined, while the development board typically requires some HW modification as e.g. described [here](https://github.com/ARMmbed/sal-nanostack-driver-stm32-eth)!
Wolfgang Betz 50:7f70089ba05f 11
Wolfgang Betz 50:7f70089ba05f 12 This driver is used with 6LoWPAN stack.