DigiMesh AT Commands example for mbed XBeeLib By Digi
Fork of XBeeZB_AT_Commands by
This example shows how to read and change configuration parameters of either the local XBee module or a remote XBee module.
See Configuring local and remote modules chapter for more information.
Common Setup
Make sure you have a valid Example Common Setup
Example Setup
Application
You have to configure the remote device 64-bit address by customizing the REMOTE_NODE_ADDR64_MSB and REMOTE_NODE_ADDR64_LSB defines with the remote XBee module 64-bit address.
Running the example
Build and deploy the example to the mbed module.
Reset the mbed module so the example starts. You should see the example debug information through the debug interface configured in the 'Local Setup' chapter.
The application will do following operations:
Operation | XBee module | parameter | Verification |
---|---|---|---|
Read | local | SL | The result is asserted against the known local module SL value. So just check the assertion passed |
Set | local | NI | Click 'discover remote devices' on the X-CTU connected to the remote. Should discover the local XBee module with the new NI (ni_example_local) |
Read | remote | SL | The result is asserted against the known remote module SL value. So just check the assertion passed |
Set | remote | NI | Refresh the 'NI' parameter in the X-CTU connected to the remote and check it has changed to the new NI (ni_example_remote) |
Diff: config.h
- Revision:
- 1:f5686759c861
- Parent:
- 0:fd8c52820c01
- Child:
- 3:91b39019eec3
diff -r fd8c52820c01 -r f5686759c861 config.h --- a/config.h Wed Apr 29 17:58:33 2015 +0200 +++ b/config.h Tue May 05 18:29:29 2015 +0200 @@ -12,7 +12,6 @@ #define ENABLE_PM_SUPPORT #define SYNC_OPS_TIMEOUT_MS 2000 -#define REM_SYNC_OPS_TIMEOUT_MS 3000 #if defined(PATFORM_ARCHPRO) #define RADIO_TX P4_28