Configure the project with uvision5¶

We have exported the project with the command mbed export and we have configured it in order to permit you to debug this application. Due to versioning problem with uvision we have listed here the right configuration of the project. Please check the following steps in order to be sure you have the project configurated properly.

1. Download the last version of the project

2. In the root folder of the project there is a file named mbed-os-sensor-node.uvprojectx. Open it with uvision.

3. From the menu click on Project -> Options for Target 'mbed-sensor-node'

4. In the Target tab, check the values marked in the red ellipse:

5. In the Debug tab click on Settings button for the ST-Link Debugger:

6. Check Connect with Pre-reset and then click on Flash Download

7. If there isn't a programming algorithm click on Add button:

8. Then add the algorithm STM32L4xx 1MB Flash

At this point you are ready to debug your application via mini-usb cable.