project for eddystone
Dependencies: BLE_API mbed nRF51822
Fork of BLE_URIBeacon by
main.cpp
- Committer:
- mbedAustin
- Date:
- 2014-12-04
- Revision:
- 9:e7f47bec97b8
- Parent:
- 8:b816829fb712
- Child:
- 11:c77cc2b74101
File content as of revision 9:e7f47bec97b8:
/* mbed Microcontroller Library * Copyright (c) 2006-2013 ARM Limited * * Licensed under the Apache License, Version 2.0 (the "License"); * you may not use this file except in compliance with the License. * You may obtain a copy of the License at * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. */ #include "mbed.h" #include "BLEDevice.h" #include "URIBeaconConfigService.h" BLEDevice ble; URIBeaconConfigService *uriBeaconConfig; /*If beacon gets disconnected start advertising again */ void disconnectionCallback(Gap::Handle_t handle, Gap::DisconnectionReason_t reason) { ble.startAdvertising(); } /* * The main loop. * Here we will configure the URI Beacon and start advertising */ int main(void) { /* Initialize BLE base layer*/ ble.init(); ble.onDisconnection(disconnectionCallback); /* Set the BLE device to be a URI Beacon, set advertising payload the address after the preamble (www.) can be 17bytes at most.*/ uriBeaconConfig = new URIBeaconConfigService(ble, "http://www.developer.mbed.org"); /*Check that the URI Beacon started successfully.*/ if (!uriBeaconConfig->configuredSuccessfully()) { error("failed to accommodate URI"); } /* optional use of the API offered by URIBeaconConfigService */ const int8_t powerLevels[] = {-20, -4, 0, 10}; uriBeaconConfig->setTxPowerLevels(powerLevels); // Set TX power levels, Lowest(-20), Low(-4), Medium(0), High(10) uriBeaconConfig->setTxPowerMode(URIBeaconConfigService::TX_POWER_MODE_LOW); // Initialize tranmition in Low power mode /*Start advertising the URI Beacon*/ ble.startAdvertising(); while (true) { ble.waitForEvent(); } }