Extending the X_NUCLEO_IDW01M1 to allow configuration of the board as an access point

Dependents:   X_NUCLEO_IDW01M1_AP_Test

Fork of X_NUCLEO_IDW01M1 by ST

Revision:
6:e7a3fca2df10
Parent:
5:c83ffd44f40a
Child:
7:0fdd186a7d90
--- a/Spwf/wifi_interface.c	Wed May 04 12:16:20 2016 +0000
+++ b/Spwf/wifi_interface.c	Mon May 09 10:38:22 2016 +0000
@@ -624,75 +624,7 @@
 return status; 
 }
 
-/**
-* @brief  wifi_socket_server_write
-*         Write to a Server socket
-* @param  None
-* @retval WiFi_Status_t : return status of server socket request
-*/
-WiFi_Status_t wifi_socket_server_write(uint16_t DataLength,char * pData) 
-{
-WiFi_Status_t status = WiFi_MODULE_SUCCESS;
-/*Can only write if there is a client connected*/
-if(!wifi_client_connected)
-{
-return WiFi_NOT_READY;
-}
- __disable_irq();
 
-status_flag.do_not_reset_push_WIFI_event = WIFI_TRUE;
-status_flag.prevent_push_WIFI_event = WIFI_TRUE;
-__enable_irq();
-
-while(status_flag.sock_read_ongoing || WIND64_count!= 0)//wait till any pending data is read
-{
-    asm("NOP");
-}
-
-wait_for_command_mode();
-
-/*to make sure that by default the mode is not switched to command mode from data mode*/
-status_flag.switch_by_default_to_command_mode = WIFI_FALSE;
-
-/*Switch to Data Mode first*/
-if(!status_flag.data_mode)
-{
-WiFi_switch_to_data_mode();//switch by default
-while(!status_flag.data_mode)
-{
-  //Wait till data_mode is active
-    asm("NOP");
-}
-}  
-
-/*Write the data on the uart*/
-/*if(HAL_UART_Transmit(&UartWiFiHandle, (uint8_t *)pData, DataLength,1000)!= HAL_OK)
-{
-Error_Handler();
-return WiFi_HAL_UART_ERROR;
-}*/
-//HAL_Delay(100);//Wait for tx before switching back to command mode
-
-/*Switch back to Command Mode*/
-if(!status_flag.command_mode)
-{
-WiFi_switch_to_command_mode();//switch by default
-while(!status_flag.command_mode)
-{
-  //Wait till command_mode is active
-    asm("NOP");
-}
-}
-
-status_flag.switch_by_default_to_command_mode = WIFI_TRUE;  /*back to default behaviour*/
-
-__disable_irq();
-status_flag.prevent_push_WIFI_event = WIFI_FALSE;
-status_flag.do_not_reset_push_WIFI_event = WIFI_FALSE;
-__enable_irq();
-
-return status;
-}
 
 /**
 * @brief  Server Socket Close