![](/media/cache/img/default_profile.jpg.50x50_q85.jpg)
AT terminal for the mDot using the USB debug port instead of the serial port.
Dependencies: MTS-Serial libmDot-mbed5
Fork of Dot-AT-Firmware by
ATSerialFlowControl.h
- Committer:
- Mike Fiore
- Date:
- 2016-04-04
- Revision:
- 9:ff62b20f7000
File content as of revision 9:ff62b20f7000:
#ifndef ATSERIALFLOWCONTROL_H #define ATSERIALFLOWCONTROL_H #include "ATSerial.h" namespace mts { /** This class derives from MTSBufferedIO/ATSerial and provides a buffered wrapper to the * standard mbed Serial class along with generic RTS/CTS HW flow control. Since it * depends only on the mbed Serial, DigitalOut and DigitalIn classes for accessing * the serial data, this class is inherently portable accross different mbed platforms * and provides HW flow control even when not natively supported by the processors * serial port. If HW flow control is not needed, use ATSerial instead. It should also * be noted that the RTS/CTS functionality in this class is implemented as a DTE device. */ class ATSerialFlowControl : public ATSerial { public: /** Creates a new ATSerialFlowControl object that can be used to talk to an mbed serial * port through internal SW buffers. Note that this class also adds the ability to use * RTS/CTS HW Flow Conrtol through and standard mbed DigitalIn and DigitalOut pins. * The RTS and CTS functionality assumes this is a DTE device. * * @param TXD the transmit data pin on the desired mbed serial interface. * @param RXD the receive data pin on the desired mbed serial interface. * @param RTS the DigitalOut pin that RTS will be attached to. (DTE) * @param CTS the DigitalIn pin that CTS will be attached to. (DTE) * @param txBufferSize the size in bytes of the internal SW transmit buffer. The * default is 256 bytes. * @param rxBufferSize the size in bytes of the internal SW receive buffer. The * default is 256 bytes. */ ATSerialFlowControl(PinName TXD, PinName RXD, PinName RTS, PinName CTS, int txBufSize = 256, int rxBufSize = 256); /** Destructs an ATSerialFlowControl object and frees all related resources. */ virtual ~ATSerialFlowControl(); //Overriden from MTSBufferedIO to support flow control correctly virtual void rxClear(); private: void notifyStartSending(); // Used to set cts start signal void notifyStopSending(); // Used to set cts stop signal //This device acts as a DTE bool rxReadyFlag; //Tracks state change for rts signaling DigitalOut rts; // Used to tell DCE to send or not send data DigitalIn cts; // Used to check if DCE is ready for data int highThreshold; // High water mark for setting cts to stop int lowThreshold; // Low water mark for setting cts to start virtual void handleRead(); // Method for handling data to be read virtual void handleWrite(); // Method for handling data to be written }; } #endif /* MTSSERIALFLOWCONTROL */