Nrithya Theetharappan / easy-connect-httpmodified

easy connect wnc added to http request with debug mode enabled. traces collected for AT%CGEQOS, AT%MEAS, AT%PCONI

Dependencies:   WNC14A2AInterface-httpmodified

Fork of easy-connect by Jim Flynn

stm-spirit1-rf-driver/README.md@8:54ac58ec99d5, 2017-12-14 (annotated)

Committer:
nrithya
Date:
Thu Dec 14 00:33:15 2017 +0000
Revision:
8:54ac58ec99d5
Parent:
0:2563b0415d1f 
easy connect wnc added to http request with debug mode enabled. traces collected for AT%CGEQOS, AT%MEAS, AT%PCONI

Who changed what in which revision?

UserRevisionLine numberNew contents of line
JMF 0:2563b0415d1f 1 # Prototype RF Driver for STM Sub-1 GHz RF Expansion Boards based on the SPSGRF-868 Module for STM32 Nucleo #
JMF 0:2563b0415d1f 2
JMF 0:2563b0415d1f 3 Currently supported boards:
JMF 0:2563b0415d1f 4 * [X-NUCLEO-IDS01A4](http://www.st.com/content/st_com/en/products/ecosystems/stm32-open-development-environment/stm32-nucleo-expansion-boards/stm32-ode-connect-hw/x-nucleo-ids01a4.html)
JMF 0:2563b0415d1f 5
JMF 0:2563b0415d1f 6 **Note**, in order to use expansion board `X-NUCLEO-IDS01A4` in mbed you need to perform the following HW modifications on the board:
JMF 0:2563b0415d1f 7 * **Un**mount resistor `R4`
JMF 0:2563b0415d1f 8 * **Mount** resistor `R7`
JMF 0:2563b0415d1f 9
JMF 0:2563b0415d1f 10 Furthermore, on some Nucleo development boards (e.g. the [NUCLEO_F429ZI](https://developer.mbed.org/platforms/ST-Nucleo-F429ZI/)), in order to be able to use Ethernet together with these Sub-1 GHz RF expansion boards, you need to compile this driver with macro `SPIRIT1_SPI_MOSI=PB_5` defined, while the development board typically requires some HW modification as e.g. described [here](https://github.com/ARMmbed/sal-nanostack-driver-stm32-eth)!
JMF 0:2563b0415d1f 11
JMF 0:2563b0415d1f 12 This driver can be used together with the 6LoWPAN stack (*a.k.a.* Nanostack).