File content as of revision 2:40d183d7dc19:

/* SPWFInterface Example
 * Copyright (c) 2015 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */

#include "SPWFSA01.h"

#define SPWFSA01_CONNECT_TIMEOUT 15000
#define SPWFSA01_SEND_TIMEOUT    500
#define SPWFSA01_RECV_TIMEOUT    1000//some commands like AT&F/W takes some time to get the result back!
#define SPWFSA01_MISC_TIMEOUT    500

SPWFSA01::SPWFSA01(PinName tx, PinName rx, bool debug)
    : _serial(tx, rx, 1024), _parser(_serial),
      _wakeup(PC_8, PIN_INPUT, PullNone, 0), _reset(PC_12, PIN_INPUT, PullNone, 1)
      //Pin PC_8 is wakeup pin
      //Pin PA_12 is reset pin
{
    _serial.baud(115200);
    _reset.output();
    _wakeup.output();
    _parser.debugOn(debug);
}

bool SPWFSA01::startup(int mode)
{
    setTimeout(SPWFSA01_RECV_TIMEOUT);
    
    /*Test module before reset*/
    waitSPWFReady();
    /*Reset module*/
    reset();
     
    /*set local echo to 0*/
    if(!(_parser.send("AT+S.SCFG=localecho1,%d", 0) && _parser.recv("OK"))) 
        {
            printf("\r\nerror local echo set\n");
            return false;
        }   
    /*reset factory settings*/
    if(!(_parser.send("AT&F") && _parser.recv("OK"))) 
        {
            printf("\r\nerror AT&F\n");
            return false;
        }

    /*set idle mode (0->idle, 1->STA,3->miniAP, 2->IBSS)*/
    if(!(_parser.send("AT+S.SCFG=wifi_mode,%d\r", mode) && _parser.recv("OK")))
        {
            printf("\r\nerror wifi mode set\n");
            return false;
        } 

    /* save current setting in flash */
    if(!(_parser.send("AT&W") && _parser.recv("OK")))
        {
            printf("\r\nerror AT&W\n");
            return false;
        }
        
    /*reset again and send AT command and check for result (AT->OK)*/
    reset();
        
    return true;    
}

bool SPWFSA01::hw_reset(void)
{    
    /* reset the pin PC12 */  
    _reset.write(0);
    wait_ms(200);
    _reset.write(1); 
    wait_ms(100);
    return 1;
}

bool SPWFSA01::reset(void)
{
    if(!_parser.send("AT+CFUN=1")) return false;
    while(1) {
        if (_parser.recv("+WIND:32:WiFi Hardware Started")) {
            return true;
        }
    }
}

void SPWFSA01::waitSPWFReady(void)
{
    //wait_ms(200);
    while(1) 
        if(_parser.send("AT") && _parser.recv("OK"))
            //till we get OK from AT command
            //printf("\r\nwaiting for reset to complete..\n");
            return;
                
}

/* Security Mode
    None          = 0, 
    WEP           = 1,
    WPA_Personal  = 2,
*/
bool SPWFSA01::connect(const char *ap, const char *passPhrase, int securityMode)
{
    uint32_t n1, n2, n3, n4;
    
    //AT+S.SCFG=wifi_wpa_psk_text,%s\r
    if(!(_parser.send("AT+S.SCFG=wifi_wpa_psk_text,%s", passPhrase) && _parser.recv("OK"))) 
        {
            printf("\r\nerror pass set\n");
            return false;
        } 
    //AT+S.SSIDTXT=%s\r
    if(!(_parser.send("AT+S.SSIDTXT=%s", ap) && _parser.recv("OK"))) 
        {
            printf("\r\nerror ssid set\n");
            return false;
        }
    //AT+S.SCFG=wifi_priv_mode,%d\r
    if(!(_parser.send("AT+S.SCFG=wifi_priv_mode,%d", securityMode) && _parser.recv("OK"))) 
        {
            printf("\r\nerror security mode set\n");
            return false;
        } 
    //"AT+S.SCFG=wifi_mode,%d\r"
    /*set idle mode (0->idle, 1->STA,3->miniAP, 2->IBSS)*/
    if(!(_parser.send("AT+S.SCFG=wifi_mode,%d\r", 1) && _parser.recv("OK")))
        {
            printf("\r\nerror wifi mode set\n");
            return false;
        }
    //AT&W
    /* save current setting in flash */
    if(!(_parser.send("AT&W") && _parser.recv("OK")))
        {
            printf("\r\nerror AT&W\n");
            return false;
        }
    //reset module
    reset();
    
    while(1)
        if((_parser.recv("+WIND:24:WiFi Up:%u.%u.%u.%u",&n1, &n2, &n3, &n4)))
        //if((_parser.recv("+WIND:24:WiFi Up:%[^\\r]",_ip_buffer)))
            {
                break;
            }
            
    //printf("\r\nip address:%u.%u.%u.%u\n",n1, n2, n3, n4);
        
    return true;
}

bool SPWFSA01::disconnect(void)
{
    //"AT+S.SCFG=wifi_mode,%d\r"
    /*set idle mode (0->idle, 1->STA,3->miniAP, 2->IBSS)*/
    if(!(_parser.send("AT+S.SCFG=wifi_mode,%d\r", 0) && _parser.recv("OK")))
        {
            printf("\r\nerror wifi mode set\n");
            return false;
        }
    //AT&W
    /* save current setting in flash */
    if(!(_parser.send("AT&W") && _parser.recv("OK")))
        {
            printf("\r\nerror AT&W\n");
            return false;
        }
    //reset module
    reset();
    return true;
}

bool SPWFSA01::dhcp(bool enabled, int mode)
{
    //only 3 valid modes
    if(mode < 0 || mode > 2) {
        return false;
    }

    return _parser.send("AT+CWDHCP=%d,%d", enabled?1:0, mode)
        && _parser.recv("OK");
}


const char *SPWFSA01::getIPAddress(void)
{
    uint32_t n1, n2, n3, n4;
    
    if (!(_parser.send("AT+S.STS=ip_ipaddr")
        && _parser.recv("#  ip_ipaddr = %u.%u.%u.%u", &n1, &n2, &n3, &n4)
        && _parser.recv("OK"))) {
            printf("\r\ngetIPAddress error\n");
        return 0;
    }

    sprintf((char*)_ip_buffer,"%u.%u.%u.%u", n1, n2, n3, n4);

    return _ip_buffer;
}

const char *SPWFSA01::getMACAddress(void)
{
    uint32_t n1, n2, n3, n4, n5, n6;
    
    if (!(_parser.send("AT+S.GCFG=nv_wifi_macaddr")
        && _parser.recv("#  nv_wifi_macaddr = %x:%x:%x:%x:%x:%x", &n1, &n2, &n3, &n4, &n5, &n6)
        && _parser.recv("OK"))) {
            printf("\r\ngetMACAddress error\n");
        return 0;
    }

    sprintf((char*)_mac_buffer,"%02X:%02X:%02X:%02X:%02X:%02X", n1, n2, n3, n4, n5, n6);

    return _mac_buffer;
}

bool SPWFSA01::isConnected(void)
{
    return getIPAddress() != 0;
}

bool SPWFSA01::open(const char *type, int id, const char* addr, int port)
{
    //IDs only 0-7
    if(id > 7) {
        return false;
    }

    return _parser.send("AT+CIPSTART=%d,\"%s\",\"%s\",%d", id, type, addr, port)
        && _parser.recv("OK");
}

bool SPWFSA01::send(int id, const void *data, uint32_t amount)
{
    //May take a second try if device is busy
    for (unsigned i = 0; i < 2; i++) {
        if (_parser.send("AT+CIPSEND=%d,%d", id, amount)
            && _parser.recv(">")
            && _parser.write((char*)data, (int)amount) >= 0) {
            return true;
        }
    }

    return false;
}

int32_t SPWFSA01::recv(int id, void *data, uint32_t amount)
{
    uint32_t recv_amount;
    int recv_id;

    if (!(_parser.recv("+IPD,%d,%d:", &recv_id, &recv_amount)
        && recv_id == id
        && recv_amount <= amount
        && _parser.read((char*)data, recv_amount)
        && _parser.recv("OK"))) {
        return -1;
    }

    return recv_amount;
}

bool SPWFSA01::close(int id)
{
    //May take a second try if device is busy
    for (unsigned i = 0; i < 2; i++) {
        if (_parser.send("AT+CIPCLOSE=%d", id)
            && _parser.recv("OK")) {
            return true;
        }
    }

    return false;
}

void SPWFSA01::setTimeout(uint32_t timeout_ms)
{
    _parser.setTimeout(timeout_ms);
}

bool SPWFSA01::readable()
{
    return _serial.readable();
}

bool SPWFSA01::writeable()
{
    return _serial.writeable();
}