File content as of revision 254:fb2a891a0d98:

/* mbed Microcontroller Library
 * Copyright (c) 2006-2013 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */

#include <stdio.h>
#include <string.h>

#include "blecommon.h"
#include "GapAdvertisingParams.h"

/**************************************************************************/
/*!
    \brief
    Instantiates a new GapAdvertisingParams instance

    \param[in]  advType
                The GAP advertising mode to use for this device. Valid
                values are defined in AdvertisingType:

                \par ADV_NON_CONNECTABLE_UNDIRECTED
                All connections to the peripheral device will be refused.

                \par ADV_CONNECTABLE_DIRECTED
                Only connections from a pre-defined central device will be
                accepted.

                \par ADV_CONNECTABLE_UNDIRECTED
                Any central device can connect to this peripheral.

                \par ADV_SCANNABLE_UNDIRECTED
                Any central device can connect to this peripheral, and
                the secondary Scan Response payload will be included or
                available to central devices.

                \par
                See Bluetooth Core Specification 4.0 (Vol. 3), Part C,
                Section 9.3 and Core Specification 4.0 (Vol. 6), Part B,
                Section 2.3.1 for further information on GAP connection
                modes

    \param[in]  interval
                Advertising interval between 0x0020 and 0x4000 in 0.625ms units
                (20ms to 10.24s).  If using non-connectable mode
                (ADV_NON_CONNECTABLE_UNDIRECTED) this min value is 0x00A0
                (100ms). To reduce the likelihood of collisions, the link layer
                perturbs this interval by a pseudo-random delay with a range of
                0 ms to 10 ms for each advertising event.

                \par
                Decreasing this value will allow central devices to detect
                your peripheral faster at the expense of more power being
                used by the radio due to the higher data transmit rate.

                \par
                This field must be set to 0 if connectionMode is equal
                to ADV_CONNECTABLE_DIRECTED

                \par
                See Bluetooth Core Specification, Vol 3., Part C,
                Appendix A for suggested advertising intervals.

    \param[in]  timeout
                Advertising timeout between 0x1 and 0x3FFF (1 and 16383)
                in seconds.  Enter 0 to disable the advertising timeout.

    \par EXAMPLE

    \code

    \endcode
*/
/**************************************************************************/
GapAdvertisingParams::GapAdvertisingParams(AdvertisingType advType, uint16_t interval, uint16_t timeout)
{
    _advType  = advType;
    _interval = interval;
    _timeout  = timeout;

    /* Interval checks */
    if (_advType == ADV_CONNECTABLE_DIRECTED) {
        /* Interval must be 0 in directed connectable mode */
        _interval = 0;
    } else if (_advType == ADV_NON_CONNECTABLE_UNDIRECTED) {
        /* Min interval is slightly larger than in other modes */
        if (_interval < GAP_ADV_PARAMS_INTERVAL_MIN_NONCON) {
            _interval = GAP_ADV_PARAMS_INTERVAL_MIN_NONCON;
        }
        if (_interval > GAP_ADV_PARAMS_INTERVAL_MAX) {
            _interval = GAP_ADV_PARAMS_INTERVAL_MAX;
        }
    } else {
        /* Stay within interval limits */
        if (_interval < GAP_ADV_PARAMS_INTERVAL_MIN) {
            _interval = GAP_ADV_PARAMS_INTERVAL_MIN;
        }
        if (_interval > GAP_ADV_PARAMS_INTERVAL_MAX) {
            _interval = GAP_ADV_PARAMS_INTERVAL_MAX;
        }
    }

    /* Timeout checks */
    if (timeout) {
        /* Stay within timeout limits */
        if (_timeout > GAP_ADV_PARAMS_TIMEOUT_MAX) {
            _timeout = GAP_ADV_PARAMS_TIMEOUT_MAX;
        }
    }
}

/**************************************************************************/
/*!
    Destructor
*/
/**************************************************************************/
GapAdvertisingParams::~GapAdvertisingParams(void)
{
}