This program displays heart rate and time between heart beats on LCD, prints it to a USB serial port, print it to a bluetooth serial port and store it on a USB mass storage device. The program has two interrupt routines: 1.Every 1ms a counter is increased with one, 2. On every heart beat the counter is value copied. In the main loop the beats per minute are calculated. Ext.Modules:- Polar RMCM-01 heart rate module connected to pin8. - 2x16 LCD - a RF-BT0417CB bluetooth serial device connected to p27 and p28 - an USB mass storage device
USBHostLite/usbhost_err.h
- Committer:
- jrsikken
- Date:
- 2011-01-04
- Revision:
- 2:e660e68a91fa
- Parent:
- 1:8b001f936bb0
File content as of revision 2:e660e68a91fa:
/* ************************************************************************************************************** * NXP USB Host Stack * * (c) Copyright 2008, NXP SemiConductors * (c) Copyright 2008, OnChip Technologies LLC * All Rights Reserved * * www.nxp.com * www.onchiptech.com * * File : usbhost_err.h * Programmer(s) : Ravikanth.P * Version : * ************************************************************************************************************** */ #ifndef USBHOST_ERR_H #define USBHOST_ERR_H /* ************************************************************************************************************** * GENERAL DEFINITIONS ************************************************************************************************************** */ #define OK 0 #define MATCH_FOUND 0 /* ************************************************************************************************************** * HOST CONTROLLER SPECIFIC ERROR CODES ************************************************************************************************************** */ #define ERR_TD_FAIL -1 /* ************************************************************************************************************** * MASS STORAGE SPECIFIC ERROR CODES ************************************************************************************************************** */ #define ERR_MS_CMD_FAILED -10 #define ERR_BAD_CONFIGURATION -11 #define ERR_NO_MS_INTERFACE -12 /* ************************************************************************************************************** * FAT SPECIFIC ERROR CODES ************************************************************************************************************** */ #define MATCH_NOT_FOUND -20 #define ERR_FAT_NOT_SUPPORTED -21 #define ERR_OPEN_LIMIT_REACHED -22 #define ERR_INVALID_BOOT_SIG -23 #define ERR_INVALID_BOOT_SEC -24 #define ERR_ROOT_DIR_FULL -25 #endif