Diff: main.cpp

Revision:

0:99422855f301

Child:

1:953e5affd67a

--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/main.cpp	Tue Mar 25 18:39:34 2014 +0000
@@ -0,0 +1,62 @@
+/**
+   @file
+   @brief Example of using the XBeeApi library to broadcast a message
+          This example has a minimum of error checking in order
+          to keep the code compact
+
+   @author John Bailey 
+
+   @copyright Copyright 2014 John Bailey
+
+   @section LICENSE
+   
+Licensed under the Apache License, Version 2.0 (the "License");
+you may not use this file except in compliance with the License.
+You may obtain a copy of the License at
+
+    http://www.apache.org/licenses/LICENSE-2.0
+
+Unless required by applicable law or agreed to in writing, software
+distributed under the License is distributed on an "AS IS" BASIS,
+WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+See the License for the specific language governing permissions and
+limitations under the License.
+
+*/
+
+#include "mbed.h"   
+#include "xbeeapi.hpp"
+ 
+uint8_t tx_data[] = { 'H', 'E', 'L', 'L', 'O' };
+
+/* TODO: You may need to change these based on the device/connections that you're using */ 
+XBeeDevice xbeeDevice( PTA2, PTA1, NC, NC );
+   
+int main() {
+    /* This example will use the blocking API for simplicity */   
+    XBeeApiCmdAtBlocking atIf( &xbeeDevice );
+
+    XBeeDevice::XBeeDeviceReturn_t status;
+
+    /* This is the frame we're going to transmit */
+    XBeeApiTxFrameEx frame( &xbeeDevice );
+        
+    /* Get API mode 2 set up - this is a pre-requisit to using other XBeeApi functions.
+       This step may not be needed in the case that the XBee has already been configured
+       to use Mode 2 and the setting has been stored in NV */
+    status = xbeeDevice.setUpApi();
+
+    if( status != XBeeDevice::XBEEDEVICE_OK )
+    {
+        /* Set the 16-bit source address of this XBee */
+        atIf.setSourceAddress( 0x1234 );
+        /* Set up a peer-to-peer network using the specified PAN and channel */
+        xbeeSetNetworkTypeP2P( &atIf, 1000, 14 );
+
+        /* Set the data pointer & destination address in the transmit frame */
+        frame.setDataPtr( tx_data, sizeof( tx_data ) );
+        frame.setDestAddr( 0x01 );
+        
+        xbeeDevice.SendFrame( &frame );    
+    }
+}
\ No newline at end of file