Joseph Ellsworth
Testing SHT75 humidity sensor on STM F303K8 board.
Fork of
Nucleo-F303K8-SSD1306_OLED
by 
Joseph Ellsworth
You are viewing an older revision! See the latest version
Homepage
Sample code to test SHT75 humidity sensor using STM F303K8 board. Uses a 3.3V from board to power sensor. 10K resistor Pull-up on data. Must not be on same pins as I2C. Uses D0 for Clk and D1 for Data.
I had to modify sample code from that supplied by https://developer.mbed.org/users/nimbusgb/code/SHT75/ because the sensor failed to read without the softReset() and readStatus() at beginning of measurement loop. I think this is caused by the 72Mhtz speed of the F303K8 but did not attempt to fully diagnose.