This is the firmware for the LaOS - Laser Open Source project. You can use it to drive a laser cutter. For hardware and more information, look at our wiki: http://wiki.laoslaser.org
Dependencies: EthernetNetIf mbed
LaosServer/EthConfig.h
- Committer:
- fablabtruck
- Date:
- 2012-06-08
- Revision:
- 0:3852426a5068
File content as of revision 0:3852426a5068:
/* * EthSetup.cpp * Setup ethernet interface, based on config file * Read IP, Gateway, DNS and port for server. * if IP is not defined, or dhcp is set, use dhcp for Ethernet * * Copyright (c) 2011 Peter Brier * * This file is part of the LaOS project (see: http://wiki.protospace.nl/index.php/LaOS) * * LaOS is free software: you can redistribute it and/or modify * it under the terms of the GNU General Public License as published by * the Free Software Foundation, either version 3 of the License, or * (at your option) any later version. * * LaOS is distributed in the hope that it will be useful, * but WITHOUT ANY WARRANTY; without even the implied warranty of * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the * GNU General Public License for more details. * * You should have received a copy of the GNU General Public License * along with LaOS. If not, see <http://www.gnu.org/licenses/>. * */ #ifndef _ETHCONFIG_H_ #define _ETHCONFIG_H_ #include "global.h" #include "EthernetNetIf.h" #include "TCPSocket.h" EthernetNetIf * EthConfig(); bool EthSpeed(void); bool EthLink(void); #endif