This is the firmware for the LaOS - Laser Open Source project. You can use it to drive a laser cutter. For hardware and more information, look at our wiki: http://wiki.laoslaser.org

Dependencies:   EthernetNetIf mbed

Revision:
0:3852426a5068
--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/LaosServer/EthConfig.h	Fri Jun 08 09:26:40 2012 +0000
@@ -0,0 +1,36 @@
+/*
+ * EthSetup.cpp
+ * Setup ethernet interface, based on config file
+ * Read IP, Gateway, DNS and port for server.
+ * if IP is not defined, or dhcp is set, use dhcp for Ethernet
+ * 
+ * Copyright (c) 2011 Peter Brier
+ *
+ *   This file is part of the LaOS project (see: http://wiki.protospace.nl/index.php/LaOS)
+ *
+ *   LaOS is free software: you can redistribute it and/or modify
+ *   it under the terms of the GNU General Public License as published by
+ *   the Free Software Foundation, either version 3 of the License, or
+ *   (at your option) any later version.
+ *
+ *   LaOS is distributed in the hope that it will be useful,
+ *   but WITHOUT ANY WARRANTY; without even the implied warranty of
+ *   MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+ *   GNU General Public License for more details.
+ *
+ *   You should have received a copy of the GNU General Public License
+ *   along with LaOS.  If not, see <http://www.gnu.org/licenses/>.
+ * 
+ */
+#ifndef _ETHCONFIG_H_
+#define _ETHCONFIG_H_
+#include "global.h"
+#include "EthernetNetIf.h"
+#include "TCPSocket.h"
+
+EthernetNetIf * EthConfig();
+bool EthSpeed(void);
+bool EthLink(void);
+
+#endif
+