Diff: config_me.h

Revision:

24:bd480d2aade4

Parent:

21:d0038d14ee7c

Child:

30:48b43538e98b

diff -r 41e6c417ace1 -r bd480d2aade4 config_me.h
--- a/config_me.h	Wed Jul 13 19:39:56 2016 +0000
+++ b/config_me.h	Wed Jul 13 20:01:12 2016 +0000
@@ -4,24 +4,35 @@
 // User must set these for own context:
 
 // This is the server's base URL name.  Example "www.google.com"
+// Note that when you Fork a FLOW, it will typically assign  either
+// "run-east.att.io" or "run-west.att.io", so be sure to check this.
 static const char * MY_SERVER_URL       = "run-west.att.io";
 
-// These are FLOW variables that must be read from your own FLOW account and placed here:
+// These are FLOW fields from the Endpoints tab:
 #define FLOW_BASE_URL                   "/1e464b19cdcde/774c88d68202/86694923d5bf28a/in/flow"
 #define FLOW_INPUT_NAME                 "/climate"
 
-// This in most cases should be left alone but is here if you want to talk a differnet protocol:
+// Unless you want to use a different protocol, this field should be left as is:
 #define FLOW_URL_TYPE                   " HTTP/1.1\r\nHost: "
 
-// This just needs to be a unique identifier 1 for each board that talks to each FLOW account. 
-// If you only have one board then you can just leave this alone but you have to use this
-// identifier in your FLOW setup for identification.
+// This identifier specifies with which FLOW device you are communicating. 
+// If you only have one devive there then you can just leave this as is.
+// Once your FLOW device has been initialized (Virtual Device Initialize clicked),
+// the Virtual Device will show up in M2X.  This is its "DEVICE SERIAL" field
 #define FLOW_DEVICE_NAME                "vstarterkit001"
 
-// These are for?
+// This constant defines how often sensors are read and sent up to FLOW
+#define SENSOR_UPDATE_INTERVAL_MS       5000; //5 seconds
+
+// Specify here how many sensor parameters you want reported to FLOW.
+// You can use only the temperature and humidity from the shield HTS221
+// or you can add the reading of the FXO8700CQ motion sensor on the FRDM-K64F board
+// or if you have a SiLabs PMOD plugged into the shield, you can add its proximity sensor,
+// UV light, visible ambient light and infrared ambient light readings
 #define TEMP_HUMIDITY_ONLY                      1
 #define TEMP_HUMIDITY_ACCELEROMETER             2
 #define TEMP_HUMIDITY_ACCELEROMETER_PMODSENSORS 3
+static int iSensorsToReport = TEMP_HUMIDITY_ONLY; //modify this to change your selection
 
 // This is the APN name for the cellular network, you will need to change this, check the instructions included with your SIM card kit:
 static const char * MY_APN_STR          = "m2m.com.attz";