Diff: targets/TARGET_Silicon_Labs/TARGET_EFM32/TARGET_EFR32MG1/TARGET_TB_SENSE_1/PinNames.h

Revision:

164:289d4deac6e4

--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/targets/TARGET_Silicon_Labs/TARGET_EFM32/TARGET_EFR32MG1/TARGET_TB_SENSE_1/PinNames.h	Wed May 10 12:06:41 2017 +0100
@@ -0,0 +1,68 @@
+/***************************************************************************//**
+ * @file PinNames.h
+ *******************************************************************************
+ * @section License
+ * <b>(C) Copyright 2015 Silicon Labs, http://www.silabs.com</b>
+ *******************************************************************************
+ *
+ * SPDX-License-Identifier: Apache-2.0
+ *
+ * Licensed under the Apache License, Version 2.0 (the "License"); you may
+ * not use this file except in compliance with the License.
+ * You may obtain a copy of the License at
+ *
+ * http://www.apache.org/licenses/LICENSE-2.0
+ *
+ * Unless required by applicable law or agreed to in writing, software
+ * distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
+ * WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+ * See the License for the specific language governing permissions and
+ * limitations under the License.
+ *
+ ******************************************************************************/
+#ifndef MBED_PINNAMES_H
+#define MBED_PINNAMES_H
+
+#include "CommonPinNames.h"
+
+#ifdef __cplusplus
+extern "C" {
+#endif
+
+typedef enum {
+    EFM32_STANDARD_PIN_DEFINITIONS,
+
+    /* Starter Kit says LED0 and LED1, but mbed expects 1 and 2. This way using 1 and 2 or 0 and 1 will work. */
+    LED0 = PD11,
+    LED1 = PD12,
+    LED2 = LED0,
+    LED3 = LED0,
+    LED4 = LED1,
+
+    /* Push Buttons */
+    SW0 = PD14,
+    SW1 = PD15,
+    BTN0 = SW0,
+    BTN1 = SW1,
+    // Standardized button names
+    BUTTON1 = BTN0,
+    BUTTON2 = BTN1,
+
+    /* Serial (just some usable pins) */
+    SERIAL_TX   = PD10,
+    SERIAL_RX   = PD11,
+
+    /* Board Controller UART (USB)*/
+    USBTX       = PA0,
+    USBRX       = PA1,
+
+    /* Board Controller */
+    STDIO_UART_TX = USBTX,
+    STDIO_UART_RX = USBRX
+} PinName;
+
+#ifdef __cplusplus
+}
+#endif
+
+#endif