Andrew R

Necton, United Kingdom

Novice.  Absolute novice. Destined to forever remain on the steepest part of the learning curve.

Andrew’s activity

Question asked: Calculation always evaluates to 0: Hello, in the code snippet below, both gain_range and gain_SYSTEM are declared as float earlier ...
Andrew R - 02 Dec 2018
New program: M1707_Controller_restore2 - 30 November backup
Andrew R - 30 Nov 2018
Question asked: wait_(nn) and interrupts Question: I use the wait_(nn) function quite a lot. My question is: if I disable interrupts, ...
Andrew R - 09 Sep 2018
Question asked: Disabling and enabling IRQ's on the LPC1114: Hi, I am using ##select_int.fall(&select_isr); ## to enable an unterrupt. Depending on the system status, ...
Andrew R - 07 Sep 2018
Question asked: Documentation: Can someone kindly point me to where there is a programming reference for mbed. I ...
Andrew R - 26 Sep 2017
Answer posted for Question: Copy Paste with mbed editor - It seems we still have this problem - its pretty serious in my view. Are ...
Andrew R - 16 Feb 2017
Question asked: USB Virtual serial port with Tera Term: Hello. I have used Tera term with my mbed1768 for a few years without problems. ...
Andrew R - 12 Jun 2016
Question asked: Strange compiler Error 147 and 135 in InterruptIn: I have declared an interrupt like this:- InterruptIn tone_isr(dp15); My main() looks like this:- tone.mode(PullUp); ...
Andrew R - 01 Dec 2015
New topic LPC1114 GPIO IRQ's - I tested all the LPC1114 GPIO pins for 1. Low going edge triggers an IRQ ...
Andrew R - 28 Nov 2015
Question asked: Are any peripherals active on power-up?: Hello, some general newbie questions:- 1. When the mbed (LPC1114, LPC11U24, LPC1768 et al) comes ...
Andrew R - 26 Nov 2015

Andrew’s public repositories

See all repositories