Diff: targets/TARGET_STM/TARGET_STM32F4/TARGET_STM32F429xI/TARGET_NUCLEO_F429ZI/system_stm32f4xx.c

Revision:

160:d5399cc887bb

Parent:

158:b23ee177fd68

Child:

167:e84263d55307

diff -r 612c381a210f -r d5399cc887bb targets/TARGET_STM/TARGET_STM32F4/TARGET_STM32F429xI/TARGET_NUCLEO_F429ZI/system_stm32f4xx.c
--- a/targets/TARGET_STM/TARGET_STM32F4/TARGET_STM32F429xI/TARGET_NUCLEO_F429ZI/system_stm32f4xx.c	Tue Feb 28 17:13:35 2017 +0000
+++ b/targets/TARGET_STM/TARGET_STM32F4/TARGET_STM32F429xI/TARGET_NUCLEO_F429ZI/system_stm32f4xx.c	Tue Mar 14 16:40:56 2017 +0000
@@ -38,7 +38,7 @@
   ******************************************************************************
   * @attention
   *
-  * <h2><center>&copy; COPYRIGHT 2016 STMicroelectronics</center></h2>
+  * <h2><center>&copy; COPYRIGHT 2017 STMicroelectronics</center></h2>
   *
   * Redistribution and use in source and binary forms, with or without modification,
   * are permitted provided that the following conditions are met:
@@ -80,6 +80,7 @@
 
 #include "stm32f4xx.h"
 #include "hal_tick.h"
+#include "nvic_addr.h"
 
 #if !defined  (HSE_VALUE) 
   #define HSE_VALUE    ((uint32_t)8000000) /*!< Default value of the External oscillator in Hz */
@@ -187,10 +188,6 @@
   */
 void SystemInit(void)
 {
-  /* FPU settings ------------------------------------------------------------*/
-  #if (__FPU_PRESENT == 1) && (__FPU_USED == 1)
-    SCB->CPACR |= ((3UL << 10*2)|(3UL << 11*2));  /* set CP10 and CP11 Full Access */
-  #endif
   /* Reset the RCC clock configuration to the default reset state ------------*/
   /* Set HSION bit */
   RCC->CR |= (uint32_t)0x00000001;
@@ -214,13 +211,6 @@
   SystemInit_ExtMemCtl(); 
 #endif /* DATA_IN_ExtSRAM || DATA_IN_ExtSDRAM */
 
-  /* Configure the Vector Table location add offset address ------------------*/
-#ifdef VECT_TAB_SRAM
-  SCB->VTOR = SRAM_BASE | VECT_TAB_OFFSET; /* Vector Table Relocation in Internal SRAM */
-#else
-  SCB->VTOR = FLASH_BASE | VECT_TAB_OFFSET; /* Vector Table Relocation in Internal FLASH */
-#endif
-
   /* Configure the Cube driver */
   SystemCoreClock = 16000000; // At this stage the HSI is used as system clock
   HAL_Init();