A copy of the mbed USBDevice with USBSerial library
Dependents: STM32L0_LoRa Smartage STM32L0_LoRa Turtle_RadioShuttle
targets/TARGET_Silicon_Labs/inc/em_usbtypes.h
- Committer:
- Helmut64
- Date:
- 2018-02-05
- Revision:
- 0:a3ea811f80f2
File content as of revision 0:a3ea811f80f2:
/***************************************************************************//** * @file em_usbtypes.h * @brief USB protocol stack library, internal type definitions. * @version 3.20.14 ******************************************************************************* * @section License * <b>(C) Copyright 2014 Silicon Labs, http://www.silabs.com</b> ******************************************************************************* * * Licensed under the Apache License, Version 2.0 (the "License"); * you may not use this file except in compliance with the License. * You may obtain a copy of the License at * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. * ******************************************************************************/ #ifndef __EM_USBTYPES_H #define __EM_USBTYPES_H #include "em_device.h" #if defined( USB_PRESENT ) && ( USB_COUNT == 1 ) #include "em_usb.h" #if defined( USB_DEVICE ) || defined( USB_HOST ) #ifdef __cplusplus extern "C" { #endif /** @cond DO_NOT_INCLUDE_WITH_DOXYGEN */ /* Limits imposed by the USB peripheral */ #define NP_RX_QUE_DEPTH 8 #define HP_RX_QUE_DEPTH 8 #define MAX_XFER_LEN 524287L /* 2^19 - 1 bytes */ #define MAX_PACKETS_PR_XFER 1023 /* 2^10 - 1 packets */ #if defined( _USB_DIEPTXF6_MASK ) #define MAX_NUM_TX_FIFOS 6 /* In addition to EP0 Tx FIFO */ #define MAX_NUM_IN_EPS 6 /* In addition to EP0 */ #define MAX_NUM_OUT_EPS 6 /* In addition to EP0 */ #define MAX_DEVICE_FIFO_SIZE_INWORDS 512U #else #define MAX_NUM_TX_FIFOS 3 /* In addition to EP0 Tx FIFO */ #define MAX_NUM_IN_EPS 3 /* In addition to EP0 */ #define MAX_NUM_OUT_EPS 3 /* In addition to EP0 */ #define MAX_DEVICE_FIFO_SIZE_INWORDS 384U #endif #define MIN_EP_FIFO_SIZE_INWORDS 16U /* Unit is words (32bit) */ #define MIN_EP_FIFO_SIZE_INBYTES 64U /* Unit is bytes (8bit) */ /* For MCU's without USB host capability. */ #if !defined( USB_ROUTE_VBUSENPEN ) #define USB_VBUS_SWITCH_NOT_PRESENT #endif /* Limit imposed by the USB standard */ #define MAX_USB_EP_NUM 15 #if defined( USB_DEVICE ) /* Check power saving modes. */ #ifndef USB_PWRSAVE_MODE /* Default powersave-mode is OFF. */ #define USB_PWRSAVE_MODE USB_PWRSAVE_MODE_OFF #else #if ( USB_PWRSAVE_MODE & \ ~( USB_PWRSAVE_MODE_ONSUSPEND | USB_PWRSAVE_MODE_ONVBUSOFF | \ USB_PWRSAVE_MODE_ENTEREM2 ) ) #error "Illegal USB powersave mode." #endif #endif /* ifndef USB_PWRSAVE_MODE */ /* Check power saving low frequency clock selection. */ #ifndef USB_USBC_32kHz_CLK /* Default clock source is LFXO. */ #define USB_USBC_32kHz_CLK USB_USBC_32kHz_CLK_LFXO #else #if ( ( USB_USBC_32kHz_CLK != USB_USBC_32kHz_CLK_LFXO ) && \ ( USB_USBC_32kHz_CLK != USB_USBC_32kHz_CLK_LFRCO ) ) #error "Illegal USB 32kHz powersave clock selection." #endif #endif /* ifndef USB_USBC_32kHz_CLK */ #endif /* defined( USB_DEVICE ) */ #if defined( USB_HOST ) /* Check VBUS overcurrent definitions. */ #ifndef USB_VBUSOVRCUR_PORT #define USB_VBUSOVRCUR_PORT gpioPortE #define USB_VBUSOVRCUR_PIN 2 #define USB_VBUSOVRCUR_POLARITY USB_VBUSOVRCUR_POLARITY_LOW #endif #endif /* Developer mode debugging macro's */ #if defined( DEBUG_USB_INT_LO ) #define DEBUG_USB_INT_LO_PUTS( s ) USB_PUTS( s ) #define DEBUG_USB_INT_LO_PUTCHAR( c ) USB_PUTCHAR( c ) #else #define DEBUG_USB_INT_LO_PUTS( s ) #define DEBUG_USB_INT_LO_PUTCHAR( c ) #endif /* defined( DEBUG_USB_INT_LO ) */ #if defined( DEBUG_USB_INT_HI ) #define DEBUG_USB_INT_HI_PUTS( s ) USB_PUTS( s ) #define DEBUG_USB_INT_HI_PUTCHAR( c ) USB_PUTCHAR( c ) #else #define DEBUG_USB_INT_HI_PUTS( s ) #define DEBUG_USB_INT_HI_PUTCHAR( c ) #endif /* defined( DEBUG_USB_INT_HI ) */ #if defined( USB_HOST ) #if defined( NUM_APP_TIMERS ) #define HOSTPORT_TIMER_INDEX (NUM_APP_TIMERS) #else #define HOSTPORT_TIMER_INDEX (0) #endif #define HOSTCH_TIMER_INDEX (HOSTPORT_TIMER_INDEX + 1 ) #endif /* Macros for selecting a hardware timer. */ #define USB_TIMER0 0 #define USB_TIMER1 1 #define USB_TIMER2 2 #define USB_TIMER3 3 #if defined( USB_HOST ) #define HCS_NAK 0x01 #define HCS_STALL 0x02 #define HCS_XACT 0x04 #define HCS_TGLERR 0x08 #define HCS_BABBLE 0x10 #define HCS_TIMEOUT 0x20 #define HCS_COMPLETED 0x40 #define HCS_RETRY 0x80 #endif #if defined( USB_DEVICE ) typedef enum { D_EP_IDLE = 0, D_EP_TRANSMITTING = 1, D_EP_RECEIVING = 2, D_EP0_IN_STATUS = 3, D_EP0_OUT_STATUS = 4 } USBD_EpState_TypeDef; typedef struct { bool in; uint8_t zlp; uint8_t num; uint8_t addr; uint8_t type; uint8_t txFifoNum; uint8_t *buf; uint16_t packetSize; uint16_t mask; uint32_t remaining; uint32_t xferred; uint32_t hwXferSize; uint32_t fifoSize; USBD_EpState_TypeDef state; USB_XferCompleteCb_TypeDef xferCompleteCb; } USBD_Ep_TypeDef; typedef struct { USB_Setup_TypeDef *setup; USB_Setup_TypeDef setupPkt[3]; uint8_t configurationValue; /* Must be DWORD aligned */ bool remoteWakeupEnabled; uint8_t numberOfStrings; uint8_t numberOfInterfaces; USBD_State_TypeDef state; USBD_State_TypeDef savedState; USBD_State_TypeDef lastState; const USB_DeviceDescriptor_TypeDef *deviceDescriptor; const USB_ConfigurationDescriptor_TypeDef *configDescriptor; const void * const *stringDescriptors; const USBD_Callbacks_TypeDef *callbacks; USBD_Ep_TypeDef ep[ NUM_EP_USED + 1 ]; uint8_t inEpAddr2EpIndex[ MAX_USB_EP_NUM + 1 ]; uint8_t outEpAddr2EpIndex[ MAX_USB_EP_NUM + 1 ]; uint32_t ep0MpsCode; } USBD_Device_TypeDef; #endif /* defined( USB_DEVICE ) */ #if defined( USB_HOST ) typedef enum { H_PORT_DISCONNECTED = 0, H_PORT_CONNECTED_DEBOUNCING = 1, H_PORT_CONNECTED_RESETTING = 2, H_PORT_CONNECTED = 3, H_PORT_OVERCURRENT = 4 } USBH_PortState_TypeDef; typedef struct { int debounceTime; int resetTime; } USBH_AttachTiming_TypeDef; typedef struct { uint8_t *buf; int errorCnt; uint32_t remaining; uint32_t xferred; uint32_t hwXferSize; uint8_t status; bool idle; USBH_Ep_TypeDef *ep; } USBH_Hc_TypeDef; #endif /* defined( USB_HOST ) */ /** @endcond */ #ifdef __cplusplus } #endif #endif /* defined( USB_DEVICE ) || defined( USB_HOST ) */ #endif /* defined( USB_PRESENT ) && ( USB_COUNT == 1 ) */ #endif /* __EM_USBTYPES_H */