![](/media/cache/img/default_profile.jpg.50x50_q85.jpg)
Fork with SeeedStudio Xadow GPS v2 enabled
Dependencies: FXOS8700CQ MODSERIAL XadowGPS mbed
Fork of Avnet_ATT_Cellular_IOT by
config_me.h
- Committer:
- stefanrousseau
- Date:
- 2016-07-13
- Revision:
- 24:bd480d2aade4
- Parent:
- 21:d0038d14ee7c
- Child:
- 50:8ac42961458c
File content as of revision 24:bd480d2aade4:
#ifndef __CONFIG_ME_H_ #define __CONFIG_ME_H_ // User must set these for own context: // This is the server's base URL name. Example "www.google.com" // Note that when you Fork a FLOW, it will typically assign either // "run-east.att.io" or "run-west.att.io", so be sure to check this. static const char * MY_SERVER_URL = "run-west.att.io"; // These are FLOW fields from the Endpoints tab: #define FLOW_BASE_URL "/1e464b19cdcde/774c88d68202/86694923d5bf28a/in/flow" #define FLOW_INPUT_NAME "/climate" // Unless you want to use a different protocol, this field should be left as is: #define FLOW_URL_TYPE " HTTP/1.1\r\nHost: " // This identifier specifies with which FLOW device you are communicating. // If you only have one devive there then you can just leave this as is. // Once your FLOW device has been initialized (Virtual Device Initialize clicked), // the Virtual Device will show up in M2X. This is its "DEVICE SERIAL" field #define FLOW_DEVICE_NAME "vstarterkit001" // This constant defines how often sensors are read and sent up to FLOW #define SENSOR_UPDATE_INTERVAL_MS 5000; //5 seconds // Specify here how many sensor parameters you want reported to FLOW. // You can use only the temperature and humidity from the shield HTS221 // or you can add the reading of the FXO8700CQ motion sensor on the FRDM-K64F board // or if you have a SiLabs PMOD plugged into the shield, you can add its proximity sensor, // UV light, visible ambient light and infrared ambient light readings #define TEMP_HUMIDITY_ONLY 1 #define TEMP_HUMIDITY_ACCELEROMETER 2 #define TEMP_HUMIDITY_ACCELEROMETER_PMODSENSORS 3 static int iSensorsToReport = TEMP_HUMIDITY_ONLY; //modify this to change your selection // This is the APN name for the cellular network, you will need to change this, check the instructions included with your SIM card kit: static const char * MY_APN_STR = "m2m.com.attz"; //This is for normal HTTP. If you want to use TCP to a specific port, change that here: static const char * MY_PORT_STR = "80"; #endif