ST / Mbed OS TeseoLocation

Teseo Location demo for GPSProvider using ST GNSS driver.

Dependencies:   GPS_Provider X_NUCLEO_GNSS1A1

Getting Started with X-NUCLEO-GNSS1A1

This example demonstrates how to use the X-NUCLEO-GNSS1A1 component with one of the STM32 Nucleo-64 platforms and how real time GNSS data received by the Teseo-LIV3F device can be displayed through a serial connection and a serial terminal on a PC. Furthermore the user can run commands enabling three advanced features:

• Geofencing
• Odometer
• Data Logging

Setup

Once the antenna has been connected to the SMA female connector of the X-NUCLEO-GNSS1A1 plugged on top of the STM32 Nucleo, a serial connection should be set up between the STM32 Nucleo and the PC with the following parameters:

• baud rate: 115200
• data: 8 bit
• parity: none
• stop: 1bit
• flow control: none
• New-line (Tx/Rx): CR

Serial connection parameters

The user can select among different options to:

• get in a human readable format information related to the acquired GNSS position (or the satellites in view, the active satellites, and so on)
• enable feature (geofencing, odometer, data logging)
• configure a geofence circle
• require geofence status
• start/stop feature (odometer, data logging)

Application menu

https://github.com/ARMmbed/mbed-os/#ecb3c8c837162c73537bd0f3592c6e2a42994045