Rigado
mbed-src updated for BMD-200 evaluation board. Just pin numbers are updated.
Dependents: mbed_blinky-bmd-200 bmd-200_accel_demo firstRig
Fork of
mbed-src
by 
mbed official
Replacement for the "mbed" or "mbed-src" library when using the BMD-200 Evaluation kit. This library only remaps the pin names (i.e. LED1 points to p0.01 instead of p0.18, etc) as used by the BMD-200 Evaluation board (select the nRF51822_mkit platform). All other code is untouched.
Diff: capi/board.c
- Revision:
- 4:c4bfb462ca53
diff -r c24f5ba8a7f9 -r c4bfb462ca53 capi/board.c
--- /dev/null Thu Jan 01 00:00:00 1970 +0000
+++ b/capi/board.c Wed Mar 13 15:04:05 2013 +0000
@@ -0,0 +1,55 @@
+/* mbed Microcontroller Library
+ * Copyright (c) 2006-2013 ARM Limited
+ *
+ * Licensed under the Apache License, Version 2.0 (the "License");
+ * you may not use this file except in compliance with the License.
+ * You may obtain a copy of the License at
+ *
+ * http://www.apache.org/licenses/LICENSE-2.0
+ *
+ * Unless required by applicable law or agreed to in writing, software
+ * distributed under the License is distributed on an "AS IS" BASIS,
+ * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+ * See the License for the specific language governing permissions and
+ * limitations under the License.
+ */
+#include "gpio_api.h"
+#include "wait_api.h"
+#include "toolchain.h"
+
+WEAK void mbed_die(void);
+WEAK void mbed_die(void) {
+#if defined(DEVICE_ERROR_RED)
+ gpio_t led_red; gpio_init(&led_red, LED_RED, PIN_OUTPUT);
+
+#elif defined(DEVICE_ERROR_PATTERN)
+ gpio_t led_1; gpio_init(&led_1, LED1, PIN_OUTPUT);
+ gpio_t led_2; gpio_init(&led_2, LED2, PIN_OUTPUT);
+ gpio_t led_3; gpio_init(&led_3, LED3, PIN_OUTPUT);
+ gpio_t led_4; gpio_init(&led_4, LED4, PIN_OUTPUT);
+#endif
+
+ while (1) {
+#if defined(DEVICE_ERROR_RED)
+ gpio_write(&led_red, 1);
+
+#elif defined(DEVICE_ERROR_PATTERN)
+ gpio_write(&led_1, 1);
+ gpio_write(&led_2, 0);
+ gpio_write(&led_3, 0);
+ gpio_write(&led_4, 1);
+#endif
+ wait_ms(150);
+
+#if defined(DEVICE_ERROR_RED)
+ gpio_write(&led_red, 0);
+
+#elif defined(DEVICE_ERROR_PATTERN)
+ gpio_write(&led_1, 0);
+ gpio_write(&led_2, 1);
+ gpio_write(&led_3, 1);
+ gpio_write(&led_4, 0);
+#endif
+ wait_ms(150);
+ }
+}