Rigado / mbed-src-bmd-200

mbed-src updated for BMD-200 evaluation board. Just pin numbers are updated.

Dependents:   mbed_blinky-bmd-200 bmd-200_accel_demo firstRig

Fork of mbed-src by mbed official

Replacement for the "mbed" or "mbed-src" library when using the BMD-200 Evaluation kit. This library only remaps the pin names (i.e. LED1 points to p0.01 instead of p0.18, etc) as used by the BMD-200 Evaluation board (select the nRF51822_mkit platform). All other code is untouched.

capi/board.c

Committer:
emilmont
Date:
2013-03-13
Revision:
4:c4bfb462ca53

File content as of revision 4:c4bfb462ca53:

/* mbed Microcontroller Library
 * Copyright (c) 2006-2013 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */
#include "gpio_api.h"
#include "wait_api.h"
#include "toolchain.h"

WEAK void mbed_die(void);
WEAK void mbed_die(void) {
#if   defined(DEVICE_ERROR_RED)
    gpio_t led_red; gpio_init(&led_red, LED_RED, PIN_OUTPUT);

#elif defined(DEVICE_ERROR_PATTERN)
    gpio_t led_1; gpio_init(&led_1, LED1, PIN_OUTPUT);
    gpio_t led_2; gpio_init(&led_2, LED2, PIN_OUTPUT);
    gpio_t led_3; gpio_init(&led_3, LED3, PIN_OUTPUT);
    gpio_t led_4; gpio_init(&led_4, LED4, PIN_OUTPUT);
#endif
    
    while (1) {
#if defined(DEVICE_ERROR_RED)
        gpio_write(&led_red, 1);

#elif  defined(DEVICE_ERROR_PATTERN)
        gpio_write(&led_1, 1);
        gpio_write(&led_2, 0);
        gpio_write(&led_3, 0);
        gpio_write(&led_4, 1);
#endif
        wait_ms(150);

#if   defined(DEVICE_ERROR_RED)
        gpio_write(&led_red, 0);

#elif defined(DEVICE_ERROR_PATTERN)
        gpio_write(&led_1, 0);
        gpio_write(&led_2, 1);
        gpio_write(&led_3, 1);
        gpio_write(&led_4, 0);
#endif
        wait_ms(150);
    }
}