libmDot
Dependents of libmDot
A dependent is a program or library which makes use of this library.
A drain water sensor
Demonstration TTN OTAA node
working reed with int and deep sleep
test gpio and access low level arm registers
This is a fork of the Multitech mDot LoRa Connect Example modified to log data or send from Temperature and Light Sensors connected to the mDot UDK
Grove Sensors,
Lora,
mdot,
mDot UDK
mDot connects over ABP. Transmits value light sensor.
Using personalization mode for the Multitech mDot. Works out of the box with f.e. LORIOT (just copy in DevAddr and the Keys).
Updated to libmDot 1.0.8-1
Arduino I2C temp sensor on mDot
lora sensnode
for PH sensor Hub
Demo of LoRA send/receive
Magnometer I2C communication based on mbed Elwin's I2c Example
test seeking in a file on mDot
alrm working version
Code for interfacing mdot with optical dust sensor: GP2Y1010AU0F
Easylube
This mDot firmware will allow USB to directly utilize AT command without the need the use of RS232 DB9 port.
few changes for RTS/CTS control
test for off-line flow
Demo of DHT11->mDot->TTN
Test Seriale MDOT
Demo of DHT11->mDot->TTN
schiet mij maar lek
Card Read
Read Card Reader
Da ka xi tong.
A example for lora_miun lib
For Wonjun and Jyunghun
LoRa demo for mDot with AirQuality sensors (SDS018,CMM5042) This program reads CO (CMM5042) and particle(SDS018) sensor data in specified time intervals and calculates an average readout. After a defined wait …
use additional counter with ticker for WDR
updated