![](/media/cache/group/arm_mbed.PNG.50x50_q85.png)
Demo starter application to connect WiGo to NSP and expose on-board sensors
Dependencies: NVIC_set_all_priorities cc3000_hostdriver_mbedsocket mbed nsdl_lib TEMT6200 TSI Wi-Go_eCompass_Lib_V3 WiGo_BattCharger
This is the mbed project for the IoT World Hackathon event, June 17th and 18th in Palo Also.
The setup instructions for participants are at the Setup page of this wiki:
init.cpp
- Committer:
- michaeljkoster
- Date:
- 2014-07-09
- Revision:
- 18:11b9d98ecae2
- Parent:
- 0:07581223f90c
File content as of revision 18:11b9d98ecae2:
/* mbed Microcontroller Library * Copyright (c) 2006-2013 ARM Limited * * Licensed under the Apache License, Version 2.0 (the "License"); * you may not use this file except in compliance with the License. * You may obtain a copy of the License at * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. */ #include "main.h" #include "mbed.h" #if (MY_BOARD == WIGO) #include "NVIC_set_all_priorities.h" /** * \brief Wi-Go initialization * \param none * \return none */ void init() { NVIC_set_all_irq_priorities(3); NVIC_SetPriority(SPI0_IRQn, 0x0); // Wi-Fi SPI interrupt must be higher priority than SysTick NVIC_SetPriority(PORTA_IRQn, 0x1); NVIC_SetPriority(SysTick_IRQn, 0x2); // SysTick set to lower priority than Wi-Fi SPI bus interrupt PORTA->PCR[16] |=PORT_PCR_ISF_MASK; PORTA->ISFR |= (1 << 16); } #elif (MY_BOARD == WIFI_DIPCORTEX) /** * \brief Wifi DipCortex initialization * \param none * \return none */ void init() { NVIC_SetPriority(SSP1_IRQn, 0x0); NVIC_SetPriority(PIN_INT0_IRQn, 0x1); // SysTick set to lower priority than Wi-Fi SPI bus interrupt NVIC_SetPriority(SysTick_IRQn, 0x2); } #else /** * \brief Place here init routine for your board * \param none * \return none */ void init() { } #endif