Digi International Inc. / Mbed 2 deprecated XBeeZB_node_discovery

ZigBee Node Discovery example for mbed XBeeLib By Digi

Dependencies:   XBeeLib mbed

Description

This example shows how to discover remote XBee modules based on their NI (Node Identifier) instead of using its 64-bit network address

The example demonstrates the two ways of discovering nodes:

  • Search for all nodes to identify
  • Search for only one node

See Discovering nodes in the network chapter for more information.

Common Setup

Make sure you have a valid Example Common Setup

Example Setup

You need to have your remote XBee module with a valid Node Identifier "NI" (Remember that by default its value is a space). Then customize the REMOTE_NODE_ID define in the application with that value.

Running the example

Build and deploy the example to the mbed module.
Reset the mbed module so the example starts. You should see the example debug information through the debug interface configured in the 'Local Setup' chapter.

Once joined to the coordinator, the application will try to discover the remote XBee module with NI equal to the defined REMOTE_NODE_ID. If found, it will send it a 'hello' message. Check in the "Console" tab of the X-CTU connected to the remote XBee module that the message arrived.
Then a node discovery function callback will be registered and a node discovery performed. All remote XBee modules in the network should answer. This library will process each answer and call the registered callback. The callback sends a 'Hello neighbor!' message to each discovered remote XBee module. Check in the "Console" tab of the X-CTU connected to the remote XBee module that the message arrived.

Diff: config.h

Revision:
3:ee7b06215329
Parent:
1:8bb1b111d52a
diff -r 5e41a845f211 -r ee7b06215329 config.h
--- a/config.h	Fri May 08 11:53:15 2015 +0200
+++ b/config.h	Mon May 11 18:00:30 2015 +0200
@@ -2,12 +2,12 @@
 #if !defined(__CONFIG_H_)
 #define __CONFIG_H_
 
-//#define PATFORM_ARCHPRO
+#define PATFORM_ARCHPRO
 
 /** Library configuration options */
 #define ENABLE_LOGGING
 #define ENABLE_ASSERTIONS
-#define FRAME_BUFFER_SIZE   4
+#define FRAME_BUFFER_SIZE   10
 #define MAX_FRAME_PAYLOAD_LEN  128
 #define ENABLE_PM_SUPPORT
 
@@ -16,7 +16,7 @@
 #if defined(PATFORM_ARCHPRO)
 #define RADIO_TX            P4_28
 #define RADIO_RX            P4_29
-#define RADIO_RESET         NC
+#define RADIO_RESET         P2_13
 //#define RADIO_RESET         NC
 #define RADIO_SLEEP_REQ     NC
 #define RADIO_ON_SLEEP      NC