ZigBee Receive Data example for mbed XBeeLib By Digi
Description
This example shows how to receive data from a remote XBeeZB module.
A remote XBee module sends a packet to our local XBee module though the air. The local XBee module receives the packet and sends it to the mbed module through the serial port. This library decodes the packet and calls a user defined method to process the packet.
See Receiving Data from other module chapter for more information.
Common Setup
Make sure you have a valid Example Common Setup
Example Setup
This example does not require any additional setup.
Running the example
Build and deploy the example to the mbed module.
Reset the mbed module so the example starts. You should see the example debug information through the debug interface configured in the 'Local Setup' chapter.
While the example is running, go to the "Console" tab of the X-CTU connected to the remote XBee module. Press the
"Add API frame to the list" and paste following bytes that create a new broadcast transmit request packet:
7E 00 19 10 01 00 00 00 00 00 00 FF FF FF FE 00 00 48 65 6C 6C 6F 20 58 42 65 65 21 5A
Select the frame and press the "Send selected frame" button to send the frame ("Hello XBee!") to the XBee network.
Verify that the local XBee module has received the frame by accessing the debug interface console terminal. If it was successful, the "Hello XBee!" message will be displayed there.
config.h
- Committer:
- hbujanda
- Date:
- 2015-04-29
- Revision:
- 0:0d348bfc487e
- Child:
- 1:6bb33e8b3b88
File content as of revision 0:0d348bfc487e:
#if !defined(__CONFIG_H_) #define __CONFIG_H_ //#define PATFORM_ARCHPRO /** Library configuration options */ #define ENABLE_LOGGING #define ENABLE_ASSERTIONS #define FRAME_BUFFER_SIZE 4 #define MAX_FRAME_PAYLOAD_LEN 128 #define ENABLE_PM_SUPPORT #define SYNC_OPS_TIMEOUT_MS 2000 #define REM_SYNC_OPS_TIMEOUT_MS 3000 #if defined(PATFORM_ARCHPRO) #define RADIO_TX P4_28 #define RADIO_RX P4_29 #define RADIO_RESET NC //#define RADIO_RESET NC #define RADIO_SLEEP_REQ NC #define RADIO_ON_SLEEP NC #define DEBUG_TX P0_2 #define DEBUG_RX P0_3 #elif defined(TARGET_LPC1768) #define RADIO_TX p9 #define RADIO_RX p10 #define RADIO_RESET p30 #define RADIO_SLEEP_REQ NC #define RADIO_ON_SLEEP NC #define DEBUG_TX P0_2 #define DEBUG_RX P0_3 #elif defined(TARGET_FRDM_KL25) #define RADIO_TX PTD3 #define RADIO_RX PTD2 #define RADIO_RESET NC #define RADIO_SLEEP_REQ NC #define RADIO_ON_SLEEP NC #define DEBUG_TX USBTX #define DEBUG_RX USBRX #elif (defined TARGET_LPC11U24) #define RADIO_TX p9 #define RADIO_RX p10 #define RADIO_RESET p30 #define RADIO_SLEEP_REQ NC #define RADIO_ON_SLEEP NC #define DEBUG_TX USBTX #define DEBUG_RX USBRX #else #error "Define a platform" #endif #endif /* __CONFIG_H_ */