DigiMEsh DIOs, ADCs and PWMs example for mbed XBeeLib By Digi
Fork of XBeeZB_dio_adc by
This example shows how to handle remote XBee modules DigitalInputOutputs, ADCs and PWMs. The example configures the remote XBee module pins to the desired functionality and then operates on those pins.
See Handling remote modules DIOs ADCs and PWMs chapter for more information.
Common Setup
Make sure you have a valid Example Common Setup
Example Setup
Application
You have to configure the remote device 64-bit address by customizing the REMOTE_NODE_ADDR64_MSB and REMOTE_NODE_ADDR64_LSB defines with the remote XBee module 64-bit address.
Hardware
On the Remote XBee module, wire following peripherals to the pins specified on the table and schematics or change the application pins according to your hardware setup:
Line | Pin | Value |
---|---|---|
DIO2/ADC2 | 18 | ADC (Analog Input) |
DIO3/ADC3 | 17 | Digital Input |
RSSI/DIO10 | 6 | PWM (Analog Output) |
DIO4 | 11 | Digital Output |
Running the example
Build and deploy the example to the mbed module.
Reset the mbed module so the example starts. You should see the example debug information through the debug interface configured in the 'Local Setup' chapter.
The application will do following operations:
- Configure the remote XBee module pins according to the table above.
- Do following loop every 5 seconds:
- Read DIO3_AD3 digital value
- Toggle LED associated to DIO4_AD4
- Read DIO2_AD2 analog value
- Set the led associated to PWM0 to different intensity levels
Diff: config.h
- Revision:
- 3:dd41eadd74a3
- Parent:
- 1:adeb9c8818ab
--- a/config.h Fri May 08 11:52:31 2015 +0200 +++ b/config.h Mon May 11 17:59:43 2015 +0200 @@ -2,12 +2,12 @@ #if !defined(__CONFIG_H_) #define __CONFIG_H_ -//#define PATFORM_ARCHPRO +#define PATFORM_ARCHPRO /** Library configuration options */ #define ENABLE_LOGGING #define ENABLE_ASSERTIONS -#define FRAME_BUFFER_SIZE 4 +#define FRAME_BUFFER_SIZE 10 #define MAX_FRAME_PAYLOAD_LEN 128 #define ENABLE_PM_SUPPORT @@ -16,7 +16,7 @@ #if defined(PATFORM_ARCHPRO) #define RADIO_TX P4_28 #define RADIO_RX P4_29 -#define RADIO_RESET NC +#define RADIO_RESET P2_13 //#define RADIO_RESET NC #define RADIO_SLEEP_REQ NC #define RADIO_ON_SLEEP NC