802.15.4 DIOs, ADCs and PWM example for mbed XBeeLib By Digi
This example shows how to handle remote XBee modules DigitalInputOutputs, ADCs and PWMs. The example configures the remote XBee module pins to the desired functionality and then operates on those pins.
See Handling remote modules DIOs ADCs and PWMs chapter for more information.
Make sure you have a valid Example Common Setup
You have to configure the remote device 64-bit address by customizing the REMOTE_NODE_ADDR64_MSB and REMOTE_NODE_ADDR64_LSB defines with the remote XBee module 64-bit address.
On the Remote XBee module, wire following peripherals to the pins specified on the table and schematics or change the application pins according to your hardware setup:
|DIO2/ADC2||18||ADC (Analog Input)|
|RSSI/DIO10||6||PWM (Analog Output)|
Running the example
Build and deploy the example to the mbed module.
Reset the mbed module so the example starts. You should see the example debug information through the debug interface configured in the 'Local Setup' chapter.
The application will do following operations:
- Configure the remote XBee module pins according to the table above.
- Do following loop every 5 seconds:
- Read DIO3_AD3 digital value
- Toggle LED associated to DIO4_AD4
- Read DIO2_AD2 analog value
- Set the led associated to PWM0 to different intensity levels