Digi International Inc. / Mbed 2 deprecated XBee802_Send_Data

802.15.4 Send Data example for mbed XBeeLib By Digi

Dependencies:   XBeeLib mbed

Description

This example shows how to send data to a remote XBee802 module. The application creates a message for a remote XBee module. This library encodes and sends it to the local XBee module through the serial port. Then the local XBee module sends the packet to the remote XBee module through the air.

The example shows how to send both unicast and broadcast messages.

See Sending data to another module chapter for more information.

Common Setup

Make sure you have a valid Example Common Setup

Example Setup

XBee modules

To evaluate the 16-bit addressing mode you have to configure the local XBee module and the remote XBee module with unique values... for example 0x1111 for the local and 0x2222 for the remote.

Application

Broadcast messages doesn't require any configuration, but for the unicast messages you have to configure:

• The remote device 64-bit address by customizing the REMOTE_NODE_ADDR64_MSB and REMOTE_NODE_ADDR64_LSB defines with the remote XBee module 64-bit address.
• The remote device 16-bit address by customizing the REMOTE_NODE_ADDR16 define with the remote XBee module 16-bit address.

Running the example

Build and deploy the example to the mbed module.
Reset the mbed module so the example starts. You should see the example debug information through the debug interface configured in the 'Local Setup' chapter. The application will first send a broadcast message and finally a couple of unicast messages to the configured remote XBee module (first using 64-bit addressing mode and then using 16-bit addressing mode).

Verify that the remote XBee module is receiving the frames by accessing the "Console" tab of the X-CTU. You should see there the broadcast and unicast messages.

#if !defined(__CONFIG_H_)
#define __CONFIG_H_

//#define PATFORM_ARCHPRO

/** Library configuration options */
#define ENABLE_LOGGING
#define ENABLE_ASSERTIONS
#define FRAME_BUFFER_SIZE   4
#define MAX_FRAME_PAYLOAD_LEN  128
#define ENABLE_PM_SUPPORT

#define SYNC_OPS_TIMEOUT_MS       2000

#if defined(PATFORM_ARCHPRO)
#define RADIO_TX            P4_28
#define RADIO_RX            P4_29
#define RADIO_RESET         NC
//#define RADIO_RESET         NC
#define RADIO_SLEEP_REQ     NC
#define RADIO_ON_SLEEP      NC
#define DEBUG_TX            P0_2
#define DEBUG_RX            P0_3
#elif defined(TARGET_LPC1768)
#define RADIO_TX            p9
#define RADIO_RX            p10
#define RADIO_RESET         p30
#define RADIO_SLEEP_REQ     NC
#define RADIO_ON_SLEEP      NC
#define DEBUG_TX            P0_2
#define DEBUG_RX            P0_3
#elif defined(TARGET_FRDM_KL25)
#define RADIO_TX            PTD3
#define RADIO_RX            PTD2
#define RADIO_RESET         NC
#define RADIO_SLEEP_REQ     NC
#define RADIO_ON_SLEEP      NC
#define DEBUG_TX            USBTX
#define DEBUG_RX            USBRX
#elif (defined TARGET_LPC11U24)
#define RADIO_TX            p9
#define RADIO_RX            p10
#define RADIO_RESET         p30
#define RADIO_SLEEP_REQ     NC
#define RADIO_ON_SLEEP      NC
#define DEBUG_TX            USBTX
#define DEBUG_RX            USBRX
#else
#error "Define a platform"
#endif

#endif /* __CONFIG_H_ */