Affordable and flexible platform to ease prototyping using a STM32L152RET6 microcontroller.
Table of Contents
The STM32 Nucleo board provides an affordable and flexible way for users to try out new ideas and build prototypes with any STM32 microcontroller line, choosing from the various combinations of performance, power consumption and features.
The Arduino™ connectivity support and ST Morpho headers make it easy to expand the functionality of the STM32 Nucleo open development platform with a wide choice of specialized shields.
The STM32 Nucleo board does not require any separate probe as it integrates the ST-LINK/V2-1 debugger/programmer.
- STM32L152RET6 in LQFP64 package
- ARM®32-bit Cortex®-M3 CPU
- 32 MHz max CPU frequency
- VDD from 1.65 V to 3.6 V
- 512 KB Flash
- 80 KB SRAM
- 16 KB EEPROM
- GPIO (51) with external interrupt capability
- 12-bit ADC with 21 channels
- Timers (9)
- I2C (2)
- USART (5)
- SPI (3)
- USB 2.0 full-speed
- DAC (2)
- LCD (1) 4x32 or 8x28
- Operationnal Amplifiers (2)
- Comparators (2)
- Two types of extension resources
- Arduino Uno Revision 3 connectivity
- STMicroelectronics Morpho extension pin headers for full access to all STM32 I/Os
- On-board ST-LINK/V2-1 debugger/programmer with SWD connector
- Selection-mode switch to use the kit as a standalone ST-LINK/V2-1
- Flexible board power supply
- USB VBUS or external source (3.3 V, 5 V, 7 - 12 V)
- Power management access point
- User LED (LD2)
- Two push buttons: USER and RESET
- USB re-enumeration capability: three different interfaces supported on USB
- Virtual Com port
- Mass storage (USB Disk drive) for drag'n'drop programming
- Debug port
You can find more details on the available pins and labels in the following files (link to the latest mbed-dev library version):
These headers give access to all STM32 pins.
ST X-NUCLEO boards¶
Other Non-ST boards¶
This video shows how to get started with ARM mbed Integrated Development Environment using STM32 Nucleo platform:
Nucleo ST-LINK/V2 driver installation and firmware upgrade
For more information, please refer to:
The following section describes known limitations of the platform. Note that general issues are tracked into the mbed repository available on GitHub.
- On Nucleo 64-pins boards, the D0 and D1 pins are not available per default as they are used by the STLink Virtual Comm Port. More information HERE
Tips and Tricks¶
Find more information in ST WIKI pages.
Please log in to start a discussion or ask a question.
Start new topic
|photocell||2||07 Mar 2018 by|
|Linux Xubuntu 16.04 qstlink2 utility does not work||0||24 Dec 2016 by|
|st7580 ST7580 development POWER LINE COMUNICATION||0||11 Nov 2014 by|
|offline compiler & debugger||33||15 Oct 2014 by|
|Switch clock to 32MHz||0||11 Mar 2014 by|