You are viewing an older revision! See the latest version

Getting started JKSoft Wallbot BLE

Table of Contents

    Host hardware requirement

    • Apple iPhone 4S or later (BLE enabled device)

    Install iPhone app

    Install Bluetooth remote control iPhone app called "RCBControll". This app is available in world-wide AppStore by free.

    /media/uploads/MACRUM/img_3628a.png

    Charging

    Battery can charged from micro USB connector with power switch off. During betters charging, RED LED is on. When battery is full charged, RED LED becomes turn off.

    Connect the Wallbot to iPhone

    • Launch RCBControll app
    • Tap sync button in center
      /media/uploads/MACRUM/img_3629.png
    • Select the Wallbot BLE
      /media/uploads/MACRUM/img_3630.png /media/uploads/MACRUM/img_3631.png

    Controll Wallbot from iPhone

    • Press Analog button both right and left
    • Control the Wallbot using analog stick (UP is forward and DOWN is backward)
      /media/uploads/MACRUM/img_3632.png

    Firmware update

    Firmware program will be published in the Wallbot platform page or JKSoft teams page. The firmware (mbed program binary) can be flashed using USB drag and drop programming. The power switch must turn on.

    All wikipages