Hi everyone, next newbie problem for me, I've used the mbed example code and circuit diagram both from the mbed example and sparkfun datasheet but the screen is just a rather nice shade of blue?
Any clues?
I can see that most references refer to an lcd 6100 and my sparkfun board lcd 8600 does not physically look the same as the pics in the examples.
Thanks for any help
Degs
Hi everyone, next newbie problem for me, I've used the mbed example code and circuit diagram both from the mbed example and sparkfun datasheet but the screen is just a rather nice shade of blue?
Any clues?
I can see that most references refer to an lcd 6100 and my sparkfun board lcd 8600 does not physically look the same as the pics in the examples.
Thanks for any help
Degs
Well I've thoroughly re-checked all my connections:
p5 - mosi - goes to DIO
p7 - sclk - goes to SCK
p8 - cs - goes to CS
p9 - rst - goes to RESET
vout goes to 3.3v input
gnd is gnd
vbatt goes to supply at 4.7v
Still got a nice blue screen though?
Well I've thoroughly re-checked all my connections:
p5 - mosi - goes to DIO
p7 - sclk - goes to SCK
p8 - cs - goes to CS
p9 - rst - goes to RESET
vout goes to 3.3v input
gnd is gnd
vbatt goes to supply at 4.7v
Still got a nice blue screen though?
Hi again........still struggling with my new sparkfun 'Nokia' lcd? I've drilled down through the header files etc and the question I've got is that where lcd type is stated in the public - enum part of the header file as being 6100 or 6610 does this still apply to the latest sparkfun board as my board layout of components looks different to the board in the example?
I'm still only getting a nice blue screen? I've checked the output voltage on the mosi line and its clearly doing something.
Any suggestions?
Hi again........still struggling with my new sparkfun 'Nokia' lcd? I've drilled down through the header files etc and the question I've got is that where lcd type is stated in the public - enum part of the header file as being 6100 or 6610 does this still apply to the latest sparkfun board as my board layout of components looks different to the board in the example?
I'm still only getting a nice blue screen? I've checked the output voltage on the mosi line and its clearly doing something.
Any suggestions?
Ooooops found the problem.....wiring fault board is fubar now I suspect :-)
Ooooops found the problem.....wiring fault board is fubar now I suspect :-)
Important Information for this Arm website
This site uses cookies to store information on your computer.
By continuing to use our site, you consent to our cookies.
If you are not happy with the use of these cookies, please review our
Cookie Policy
to learn how they can be disabled.
By disabling cookies, some features of the site will not work.
Access Warning
You do not have the correct permissions to perform this operation.
Hi everyone, next newbie problem for me, I've used the mbed example code and circuit diagram both from the mbed example and sparkfun datasheet but the screen is just a rather nice shade of blue? Any clues? I can see that most references refer to an lcd 6100 and my sparkfun board lcd 8600 does not physically look the same as the pics in the examples.
Thanks for any help Degs