Describes the capabilities of a SPI peripherals. More...
#include <spi_api.h>
Data Fields | |
| uint32_t | minimum_frequency |
| Minimum frequency supported must be set by target device and it will be assessed during testing. More... | |
| uint32_t | maximum_frequency |
| Maximum frequency supported must be set by target device and it will be assessed during testing. More... | |
| uint32_t | word_length |
| Each bit represents the corresponding word length. More... | |
| uint16_t | slave_delay_between_symbols_ns |
| specifies required number of ns between transmission of successive symbols in slave mode. More... | |
| uint8_t | clk_modes |
| specifies supported modes from spi_mode_t. More... | |
| bool | support_slave_mode |
| If true, the device can handle SPI slave mode using hardware management on the specified ssel pin. More... | |
| bool | hw_cs_handle |
| If true, in SPI master mode Chip Select can be handled by hardware. More... | |
| bool | async_mode |
| If true, in async mode is supported. More... | |
| bool | tx_rx_buffers_equal_length |
| If true, rx and tx buffers must have the same length. More... | |
| uint8_t clk_modes |
| bool hw_cs_handle |
| uint32_t maximum_frequency |
| uint32_t minimum_frequency |
| uint16_t slave_delay_between_symbols_ns |
| bool support_slave_mode |
| bool tx_rx_buffers_equal_length |
