Diff: sx1276/sx1276-hal.h

Revision:

31:e50929bd3f32

Parent:

29:a793ce879585

Child:

34:07e89f23c734

--- a/sx1276/sx1276-hal.h	Thu Apr 27 22:33:38 2017 +0200
+++ b/sx1276/sx1276-hal.h	Mon May 01 11:43:25 2017 +0200
@@ -17,9 +17,9 @@
 #include "sx1276.h"
 
 /*!
- * \brief Radio hardware registers initialization definition
+ * @brief Radio hardware registers initialization definition
  *
- * \remark Can be automatically generated by the SX1276 GUI (not yet implemented)
+ * @remark Can be automatically generated by the SX1276 GUI (not yet implemented)
  */
 #define RADIO_INIT_REGISTERS_VALUE                \
 {                                                 \
@@ -50,13 +50,13 @@
     /*!
      * Antenna switch GPIO pins objects
      */
-    DigitalInOut antSwitch;
+    DigitalInOut AntSwitch;
 #ifdef MURATA_ANT_SWITCH
-    DigitalInOut antSwitchTX;
-    DigitalInOut antSwitchTXBoost;
+    DigitalInOut AntSwitchTX;
+    DigitalInOut AntSwitchTXBoost;
 #endif
 
-    DigitalIn fake;
+    DigitalIn Fake;
 
 private:
     static const RadioRegisters_t RadioRegsInit[];
@@ -106,6 +106,13 @@
     virtual void IoDeInit( void );
 
     /*!
+     * \brief Sets the radio output power.
+     *
+     * @param [IN] power Sets the RF output power
+     */
+    virtual void SetRfTxPower( int8_t power );
+
+    /*!
      * @brief Gets the board PA selection configuration
      *
      * @param [IN] channel Channel frequency in Hz
@@ -128,24 +135,24 @@
     /*!
      * @brief De-initializes the RF Switch I/Os pins interface 
      *
-     * \remark Needed to decrease the power consumption in MCU lowpower modes
+     * @remark Needed to decrease the power consumption in MCU lowpower modes
      */
     virtual void AntSwDeInit( void );
 
     /*!
      * @brief Controls the antena switch if necessary.
      *
-     * \remark see errata note
+     * @remark see errata note
      *
-     * @param [IN] rxTx [1: Tx, 0: Rx]
+     * @param [IN] opMode Current radio operating mode
      */
-    virtual void SetAntSw( uint8_t rxTx );
+    virtual void SetAntSw( uint8_t opMode );
 
 public:
     /*!
      * @brief Detect the board connected by reading the value of the antenna switch pin
      */
-    virtual uint8_t DetectBoardType( void );    
+	virtual uint8_t DetectBoardType( void );
 
     /*!
      * @brief Checks if the given RF frequency is supported by the hardware