File content as of revision 153:0a78729d3229:

/* mbed Microcontroller Library
 * Copyright (c) 2006-2013 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */
#include "mbed_assert.h"
#include "gpio_api.h"
#include "pinmap.h"

static int  gpio_enabled = 0;

static void gpio_enable(void)
{
    gpio_enabled = 1;

    /* Enable AHB clock to the GPIO domain. */
    LPC_SYSCON->SYSAHBCLKCTRL |= (1 << 6);

    /* Peripheral reset control to GPIO and GPIO INT, a "1" bring it out of reset. */
    LPC_SYSCON->PRESETCTRL &= ~(1 << 10);
    LPC_SYSCON->PRESETCTRL |=  (1 << 10);
}

uint32_t gpio_set(PinName pin)
{
    if (!gpio_enabled)
         gpio_enable();

    return (1 << ((int)pin >> PIN_SHIFT));
}

void gpio_init(gpio_t *obj, PinName pin)
{
    obj->pin = pin;
    if (pin == (PinName)NC)
        return;

    obj->mask = gpio_set(pin);

    obj->reg_set = &LPC_GPIO_PORT->SET0;
    obj->reg_clr = &LPC_GPIO_PORT->CLR0;
    obj->reg_in  = &LPC_GPIO_PORT->PIN0;
    obj->reg_dir = &LPC_GPIO_PORT->DIR0;
}

void gpio_mode(gpio_t *obj, PinMode mode)
{
    pin_mode(obj->pin, mode);
}

void gpio_dir(gpio_t *obj, PinDirection direction)
{
    MBED_ASSERT(obj->pin != (PinName)NC);
    switch (direction) {
        case PIN_INPUT :
            *obj->reg_dir &= ~obj->mask;
            break;
        case PIN_OUTPUT:
            *obj->reg_dir |= obj->mask;
            break;
    }
}