File content as of revision 5:4438d5665b4f:

#define MPL3115A2_I2C_ADDRESS (0x60<<1)
#define MAG_ADDR 0x1D
// define registers
#define MAG_DR_STATUS 0x00
#define MAG_OUT_X_MSB 0x01
#define MAG_OUT_X_LSB 0x02
#define MAG_OUT_Y_MSB 0x03
#define MAG_OUT_Y_LSB 0x04
#define MAG_OUT_Z_MSB 0x05
#define MAG_OUT_Z_LSB 0x06
#define MAG_WHO_AM_I  0x07
#define MAG_SYSMOD    0x08
#define MAG_OFF_X_MSB 0x09
#define MAG_OFF_X_LSB 0x0A
#define MAG_OFF_Y_MSB 0x0B
#define MAG_OFF_Y_LSB 0x0C
#define MAG_OFF_Z_MSB 0x0D
#define MAG_OFF_Z_LSB 0x0E
#define MAG_DIE_TEMP  0x0F
#define MAG_CTRL_REG1 0x10
#define MAG_CTRL_REG2 0x11

// what should WHO_AM_I return?
#define MAG_3110_WHO_AM_I_VALUE 0xC4


// Fields in registers
// CTRL_REG1: dr2,dr1,dr0  os1,os0  fr tm ac

// Sampling rate from 80Hz down to 0.625Hz
#define MAG_3110_SAMPLE80 0
#define MAG_3110_SAMPLE40 0x20
#define MAG_3110_SAMPLE20 0x40
#define MAG_3110_SAMPLE10 0x60
#define MAG_3110_SAMPLE5 0x80
#define MAG_3110_SAMPLE2_5 0xA0
#define MAG_3110_SAMPLE1_25 0xC0
#define MAG_3110_SAMPLE0_625 0xE0

// How many samples to average (lowers data rate)
#define MAG_3110_OVERSAMPLE1 0
#define MAG_3110_OVERSAMPLE2 0x08
#define MAG_3110_OVERSAMPLE3 0x10
#define MAG_3110_OVERSAMPLE4 0x18

// read only 1 byte per axis
#define MAG_3110_FASTREAD 0x04
// do one measurement (even if in standby mode)
#define MAG_3110_TRIGGER 0x02
// put in active mode
#define MAG_3110_ACTIVE 0x01

// CTRL_REG2: AUTO_MRST_EN  _ RAW MAG_RST _ _ _ _ _
// reset sensor after each reading
#define MAG_3110_AUTO_MRST_EN 0x80
// don't subtract user offsets
#define MAG_3110_RAW 0x20
// reset magnetic sensor after too-large field
#define MAG_3110_MAG_RST 0x10

// DR_STATUS Register ZYXOW ZOW YOW XOW ZYXDR ZDR YDR XDR
#define MAG_3110_ZYXDR  0x08


#define PI 3.14159265359
#define ON  0
#define OFF 1

#define RGB_LED_ON  0
#define RGB_LED_OFF 1